UPD78F1211GB-GAF-AX Renesas Electronics America, UPD78F1211GB-GAF-AX Datasheet - Page 569

• Manufacturer Part Number: UPD78F1211GB-GAF-AX
• Description: MCU 16BIT 78K0R/LX3 44-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Ix3r

Specifications of UPD78F1211GB-GAF-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 40MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 33
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 10x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

10.4.3 Setting window open period of watchdog timer
byte (000C0H). The outline of the window is as follows.
Set the window open period of the watchdog timer by using bits 6 and 5 (WINDOW1, WINDOW0) of the option
• If “ACH” is written to WDTE during the window open period, the watchdog timer is cleared and starts counting
• Even if “ACH” is written to WDTE during the window close period, an abnormality is detected and an internal
Example: If the window open period is 25%
Caution When data is written to WDTE for the first time after reset release, the watchdog timer is cleared
The window open period to be set is as follows.
Cautions 1. The watchdog timer continues its operation during self-programming of the flash memory
Counting
starts
again.
reset signal is generated.
in any timing regardless of the window open time, as long as the register is written before the
overflow time, and the watchdog timer starts counting again.
WINDOW1
2. When bit 0 (WDSTBYON) of the option byte (000C0H) = 0, the window open period is 100%
3. Do not set the window open period to 25% if the watchdog timer corresponds to either of the
and EEPROM emulation. During processing, the interrupt acknowledge time is delayed. Set
the overflow time and window size taking this delay into consideration.
regardless of the values of WINDOW1 and WINDOW0.
conditions below.
• When stopping all main system clocks (internal high-speed oscillation clock, X1 clock, and
• Low consumption current mode
0
0
1
1
Internal reset signal is generated
if “ACH” is written to WDTE.
external main system clock) by use of the STOP mode or software.
Window close period (75%)
Table 10-4. Setting Window Open Period of Watchdog Timer
WINDOW0
1
0
1
0
25%
50%
75%
100%
CHAPTER 10 WATCHDOG TIMER
User’s Manual U19678EJ1V1UD
Window Open Period of Watchdog Timer
Counting starts again when
“ACH” is written to WDTE.
Window open
period (25%)
Overflow
time
567