C500DA101 Omron, C500DA101 Datasheet - Page 160

• Manufacturer Part Number: C500DA101
• Description: ANALOG OUTPUT UNIT
• Manufacturer: Omron

Specifications of C500DA101

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• No. Of Analog Outputs: 4
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Mounting the Terminal
Block
Mounting the Unit
9-2-2 Setting the Two-word or Four-word Operating Mode
Settings and Wiring
Rear of Unit
Backplane connector
Two/four-word mode switch
When the output signal range has been set, mount the terminal block and tighten
the upper and lower set screws.
When mounting the Unit on the Backplane, make sure that the Unit is correctly
inserted in the slot, then tighten the upper and lower mounting screws.
There is a toggle switch on the back of the Unit for selecting either two–word or
four–word mode for the I/O allocations. The factory setting is for two–word
mode.
Toggle switch setting
Two-word mode
Four-word mode
Allocated I/O mode
Factory setting
---
Section
Remarks
149
9-2