C500DA101 Omron, C500DA101 Datasheet - Page 51

• Manufacturer Part Number: C500DA101
• Description: ANALOG OUTPUT UNIT
• Manufacturer: Omron

Specifications of C500DA101

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• No. Of Analog Outputs: 4
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Functions, Settings and Wiring
Setting Procedure
Place your thumb at the bottom
left edge of the cover and push
it to the right.
Removing the Cover
1, 2, 3...
4. Follow the setting procedure described below to set the input range for each
1. Remove the cover from the front face of the Unit.
2. The numbers on the DIP switch pins (SW1) indicate the input ports 1 to 8.
3. Apply the minimum (offset) value of voltage (0 V) or current (0 mV) to input 1.
4. Set the toggle switch (SW2) down to read the offset.
5. Apply the maximum (gain) value of voltage (10 V) or current (10 mV) to input
6. Set the toggle switch (SW2) up to read the gain.
input point.
Initially, turn ON only pin 1 and make sure that all other pins are OFF.
The offset converted output is 000
1. The gain converted output is FFF
Under the Cover
SW 1
SW 2
SW 1
SW 2
SW1 (DIP switch to
select input points)
SW2 (toggle switch to
read input range)
Read offset
Read gain
Firmly press toggle switch. Toggle
switch automatically resets and returns
to original position when released.
Firmly press toggle switch. Toggle
switch automatically resets and returns
to original position when released.
Hex
Hex
Hold the cover between your thumb
and middle finger, position the lower
edge and push the cover into place
with your index finger.
.
.
Attaching the Cover
Press with a pen tip, etc.
Section 4-2
35