FW82801DB S L66K Intel, FW82801DB S L66K Datasheet - Page 127
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
FW82801DB S L66K
Manufacturer Part Number
FW82801DB S L66K
Description
Manufacturer
Intel
Datasheet
1.FW82801DB_S_L66K.pdf
(587 pages)
Specifications of FW82801DB S L66K
Lead Free Status / RoHS Status
Supplier Unconfirmed
- Current page: 127 of 587
- Download datasheet (7Mb)
5.10
5.10.1
Intel
Warning:
®
82801DB ICH4 Datasheet
Note: The ICH4 supports the ability to generate an SMI# based on Year 2000 rollover. See
Real Time Clock (D31:F0)
The Real Time Clock (RTC) module provides a battery backed-up date and time keeping device
with two banks of static RAM with 128 bytes each, although the first bank has 114 bytes for
general purpose usage. Three interrupt features are available: time of day alarm with once a second
to once a month range, periodic rates of 122 µs to 500 ms, and end of update cycle notification.
Seconds, minutes, hours, days, day of week, month, and year are counted. Daylight savings
compensation is optional. The hour is represented in twelve or twenty-four hour format, and data
can be represented in BCD or binary format. The design is meant to be functionally compatible
with the Motorola MS146818B. The time keeping comes from a 32.768 kHz oscillating source,
which is divided to achieve an update every second. The lower 14 bytes on the lower RAM block
has very specific functions. The first ten are for time and date information. The next four (0Ah to
0Dh) are registers, which configure and report RTC functions.
The time and calendar data should match the data mode (BCD or binary) and hour mode
(12 or 24 hour) as selected in register B. It is up to the programmer to make sure that data stored in
these locations is within the reasonable values ranges and represents a possible date and time. The
exception to these ranges is to store a value of C0–FF in the Alarm bytes to indicate a don’t care
situation. All Alarm conditions must match to trigger an Alarm Flag, which could trigger an Alarm
Interrupt if enabled. The SET bit must be one while programming these locations to avoid clashes
with an update cycle. Access to time and date information is done through the RAM locations. If a
RAM read from the ten time and date bytes is attempted during an update cycle, the value read will
not necessarily represent the true contents of those locations. Any RAM writes under the same
conditions will be ignored.
for more information on the century rollover.
The ICH4 does not implement month/year alarms.
Update Cycles
An update cycle occurs once a second, if the SET bit of register B is not asserted and the divide
chain is properly configured. During this procedure, the stored time and date will be incremented,
overflow will be checked, a matching alarm condition will be checked, and the time and date will
be rewritten to the RAM locations. The update cycle will start at least 488 µs after the UIP bit of
register A is asserted, and the entire cycle will not take more than 1984 µs to complete. The time
and date RAM locations (0–9) will be disconnected from the external bus during this time.
To avoid update and data corruption conditions, external RAM access to these locations can safely
occur at two times. When a updated-ended interrupt is detected, almost 999 ms is available to read
and write the valid time and date data. If the UIP bit of Register A is detected to be low, there is at
least 488 µs before the update cycle begins.
The overflow conditions for leap years and daylight savings adjustments are based on more than
one date or time item. To ensure proper operation when adjusting the time, the new time and data
values should be set at least two seconds before one of these conditions (leap year, daylight savings
time adjustments) occurs.
Functional Description
Section 5.10.4
127
Related parts for FW82801DB S L66K
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![FW82801DB S L6DM](/images/manufacturer_photos/0/3/336/intel_tmb.jpg)
Part Number:
Description:
Manufacturer:
Intel
Datasheet:
![RJ80535VC600512](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
![82550GY](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![G28F640J5-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-100](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
![DA28F640J5A-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
![NHE6300ESB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
![NH82801DB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
![FW82801FB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet: