DSPD56367PV150 Freescale Semiconductor, DSPD56367PV150 Datasheet - Page 22

• Manufacturer Part Number: DSPD56367PV150
• Manufacturer: Freescale Semiconductor

Specifications of DSPD56367PV150

• Device Core Size: 24b
• Format: Fixed Point
• Clock Freq (max): 150MHz
• Mips: 150
• Device Input Clock Speed: 150MHz
• Ram Size: 69KB
• Program Memory Size: 120KB
• Operating Supply Voltage (typ): 1.8/3.3V
• Operating Supply Voltage (min): 1.71/3.14V
• Operating Supply Voltage (max): 1.89/3.46V
• Operating Temp Range: -40C to 95C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 144
• Package Type: LQFP
• Lead Free Status / Rohs Status: Not Compliant

SPDIF Transmitter Digital Audio Interface
2.14
2.15
2-18
Signal
Name
ADO
Signal
PD0
PD1
Name
ACI
TIO0
SPDIF Transmitter Digital Audio Interface
Timer
Input, Output, or
Input, Output, or
Disconnected
Disconnected
Input or Output
Output
Type
Input
Type
Disconnected
Disconnected
State During
State during
Table 2-13 Digital Audio Interface (DAX) Signals
Reset
GPIO
GPIO
Reset
Input
DSP56367 Technical Data, Rev. 2.1
Audio Clock Input—This is the DAX clock input. When programmed to use
an external clock, this input supplies the DAX clock. The external clock
frequency must be 256, 384, or 512 times the audio sampling frequency
(256 × Fs, 384 × Fs or 512 × Fs, respectively).
Port D 0—When the DAX is configured as GPIO, this signal is individually
programmable as input, output, or internally disconnected.
The default state after reset is GPIO disconnected.
This input is 3.3V tolerant.
Digital Audio Data Output—This signal is an audio and non-audio output in
the form of AES/EBU, CP340 and IEC958 data in a biphase mark format.
Port D 1—When the DAX is configured as GPIO, this signal is individually
programmable as input, output, or internally disconnected.
The default state after reset is GPIO disconnected.
This input is 3.3V tolerant.
Table 2-14 Timer Signal
Timer 0 Schmitt-Trigger Input/Output—When timer 0 functions as an
external event counter or in measurement mode, TIO0 is used as input. When
timer 0 functions in watchdog, timer, or pulse modulation mode, TIO0 is used
as output.
The default mode after reset is GPIO input. This can be changed to output or
configured as a timer input/output through the timer 0 control/status register
(TCSR0). If TIO0 is not being used, it is recommended to either define it as
GPIO output immediately at the beginning of operation or leave it defined as
GPIO input but connected to Vcc through a pull-up resistor in order to ensure
a stable logic level at this input.
This input is 3.3 V tolerant.
Signal Description
Signal Description
Freescale Semiconductor