ATmega16HVB Atmel Corporation, ATmega16HVB Datasheet - Page 153

• Manufacturer Part Number: ATmega16HVB
• Manufacturer: Atmel Corporation

Specifications of ATmega16HVB

• Flash (kbytes): 16 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 8 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 8
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 17
• Ext Interrupts: 15
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1.9
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 1
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 4.0 to 25
• Operating Voltage (vcc): 4.0 to 25
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 4
• Input Capture Channels: 2
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

27. 2-wire serial interface
27.1
27.2
8042D–AVR–10/11
Features
Two-wire serial interface bus definition
•
•
•
•
•
•
•
•
•
•
The Two-wire Serial Interface (TWI) is ideally suited for typical microcontroller applications. The
TWI protocol allows the systems designer to interconnect up to 128 different devices using only
two bi-directional bus lines, one for clock (SCL) and one for data (SDA). The only external hard-
ware needed to implement the bus is a single pull-up resistor for each of the TWI bus lines. All
devices connected to the bus have individual addresses, and mechanisms for resolving bus
contention are inherent in the TWI protocol.
When the TWI is not used, power consumption can be minimized by writing the PRTWI bit in
PRR0 to one. See
the PRTWI bit.
Figure 27-1. TWI bus interconnection.
Simple yet powerful and flexible communication interface, only two bus lines needed
Both master and slave operation supported
Device can operate as transmitter or receiver
7-bit address space allows up to 128 different slave addresses
Multi-master arbitration support
Supports SM bus transfer speeds from 10kHz to 100kHz
Slew-rate limited output drivers
Noise suppression circuitry rejects spikes on bus lines
Fully programmable slave address with general call support
Address recognition causes wake-up when AVR is in sleep mode
SDA
SCL
Device 1
”PRR0 – Power Reduction Register 0” on page 40
Device 2
Device 3
........
ATmega16HVB/32HVB
Device n
V
BUS
R1
for details on how to use
R2
153