DSPIC30F2023 Microchip Technology Inc., DSPIC30F2023 Datasheet - Page 52

• Manufacturer Part Number: DSPIC30F2023
• Description: 28/44-pin Dspic30f1010/202x Enhanced Flash Smps 16-bit Digital Signal Controller
• Manufacturer: Microchip Technology Inc.

dsPIC30F1010/202X
Address Error Trap:
This trap is initiated when any of the following
circumstances occurs:
1.
2.
3.
4.
5.
6.
Stack Error Trap:
This trap is initiated under the following conditions:
1.
2.
Oscillator Fail Trap:
This trap is initiated if the external oscillator fails and
operation becomes reliant on an internal RC backup.
DS70178C-page 50
Note:
A misaligned data word access is attempted.
A data fetch from our unimplemented data
memory location is attempted.
A data access of an unimplemented program
memory location is attempted.
An instruction fetch from vector space is
attempted.
Execution of a “BRA #literal” instruction or a
“GOTO #literal” instruction, where literal
is an unimplemented program memory address.
Executing instructions after modifying the PC to
point to unimplemented program memory
addresses. The PC may be modified by loading
a value into the stack and executing a RETURN
instruction.
The Stack Pointer is loaded with a value which
is greater than the (user-programmable) limit
value written into the SPLIM register (stack
overflow).
The Stack Pointer is loaded with a value which
is less than 0x0800 (simple stack underflow).
In the MAC class of instructions, wherein
the data space is split into X and Y data
space, unimplemented X space includes
all of Y space, and unimplemented Y
space includes all of X space.
Preliminary
5.3.2
It is possible that multiple traps can become active
within the same cycle (e.g., a misaligned word stack
write to an overflowed address). In such a case, the
fixed priority shown in Figure 5-1 is implemented,
which may require the user to check if other traps are
pending, in order to completely correct the fault.
‘Soft’ traps include exceptions of priority level 8 through
level 11, inclusive. The arithmetic error trap (level 11)
falls into this category of traps.
‘Hard’ traps include exceptions of priority level 12
through level 15, inclusive. The address error (level
12), stack error (level 13) and oscillator error (level 14)
traps fall into this category.
Each hard trap that occurs must be acknowledged
before code execution of any type may continue. If a
lower priority hard trap occurs while a higher priority
trap is pending, acknowledged, or is being processed,
a hard trap conflict will occur.
The device is automatically Reset in a hard trap conflict
condition. The TRAPR Status bit (RCON<15>) is set
when the Reset occurs, so that the condition may be
detected in software.
FIGURE 5-1:
AIVT
IVT
HARD AND SOFT TRAPS
Oscillator Fail Trap Vector
Address Error Trap Vector
Oscillator Fail Trap Vector
Address Error Trap Vector
Reset - GOTO Instruction
Stack Error Trap Vector
Stack Error Trap Vector
Math Error Trap Vector
Math Error Trap Vector
Reset - GOTO Address
Interrupt 52 Vector
Interrupt 53 Vector
Interrupt 52 Vector
Interrupt 53 Vector
Interrupt 0 Vector
Interrupt 1 Vector
Interrupt 0 Vector
Interrupt 1 Vector
Reserved Vector
Reserved Vector
Reserved Vector
Reserved Vector
Reserved Vector
Reserved Vector
TRAP VECTORS
© 2006 Microchip Technology Inc.
Reserved
Reserved
Reserved
Reserved
—
—
—
—
—
—
0x0000FE
0x000000
0x000002
0x000004
0x000014
0x000094
0x00007E
0x000082
0x000084
0x000080