P89LPC9341FDH,512 NXP Semiconductors, P89LPC9341FDH,512 Datasheet - Page 32

• Manufacturer Part Number: P89LPC9341FDH,512
• Description: IC 80C51 MCU FLASH 8K 28-TSSOP
• Manufacturer: NXP Semiconductors
• Series: LPC900r

Specifications of P89LPC9341FDH,512

• Program Memory Type: FLASH
• Program Memory Size: 8KB (8K x 8)
• Package / Case: 28-TSSOP
• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 18MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 26
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 3.6 V
• Data Converters: A/D 8x8b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Processor Series: P89LPC
• Core: 80C51
• Data Bus Width: 8 bit
• Data Ram Size: 256 B
• Interface Type: I2C, SPI, UART
• Maximum Clock Frequency: 18 MHz
• Number Of Programmable I/os: 23
• Number Of Timers: 2
• Operating Supply Voltage: 2.4 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 2 (8 bit, 4 Channel)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 568-1758 - BOARD EVAL FOR LPC93X MCU FAMILY
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 935288632512

NXP Semiconductors
P89LPC9331_9341_9351_9361
Product data sheet
Fig 7.
(7.3728 MHz/14.7456 MHz ± 1 %)
Block diagram of oscillator control
WITH CLOCK DOUBLER
XTAL1
XTAL2
RC OSCILLATOR
7.10 CCLK wake-up delay
7.12 Low power select
7.11 CCLK modification: DIVM register
(400 kHz ± 5 %)
OSCILLATOR
WATCHDOG
The P89LPC9331/9341/9351/9361 has an internal wake-up timer that delays the clock
until it stabilizes depending on the clock source used. If the clock source is any of the
three crystal selections (low, medium and high frequencies) the delay is 1024 OSCCLK
cycles plus 60 μs to 100 μs. If the clock source is the internal RC oscillator, the delay is
200 μs to 300 μs. If the clock source is watchdog oscillator or external clock, the delay is
32 OSCCLK cycles.
The OSCCLK frequency can be divided down up to 510 times by configuring a dividing
register, DIVM, to generate CCLK. This feature makes it possible to temporarily run the
CPU at a lower rate, reducing power consumption. By dividing the clock, the CPU can
retain the ability to respond to events that would not exit Idle mode by executing its normal
program at a lower rate. This can also allow bypassing the oscillator start-up time in cases
where Power-down mode would otherwise be used. The value of DIVM may be changed
by the program at any time without interrupting code execution.
The P89LPC9331/9341/9351/9361 is designed to run at 18 MHz (CCLK) maximum.
However, if CCLK is 8 MHz or slower, the CLKLP SFR bit (AUXR1.7) can be set to logic 1
to lower the power consumption further. On any reset, CLKLP is logic 0 allowing highest
performance access. This bit can then be set in software if CCLK is running at 8 MHz or
slower.
MEDIUM FREQUENCY
HIGH FREQUENCY
LOW FREQUENCY
RCCLK
TIMER 0 AND
TIMER 1
All information provided in this document is subject to legal disclaimers.
Rev. 5 — 10 January 2011
8-bit microcontroller with accelerated two-clock 80C51 core
I
2
C-BUS
P89LPC9331/9341/9351/9361
OSCCLK
PCLK
DIVM
SPI
CCLK
PCLK
÷2
UART
(P89LPC9351/9361)
ADC1
ADC0
WDT
CPU
RTC
32 × PLL
CCU
© NXP B.V. 2011. All rights reserved.
002aad559
32 of 94