HD64F2612FA20 Renesas Electronics America, HD64F2612FA20 Datasheet - Page 143

• Manufacturer Part Number: HD64F2612FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2612FA20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 43
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

8.2.2
MRB is an 8-bit register that selects the DTC operating mode.
Bit
7
6
5 to
0
8.2.3
SAR is a 24-bit register that designates the source address of data to be transferred by the DTC.
For word-size transfer, specify an even source address.
8.2.4
DAR is a 24-bit register that designates the destination address of data to be transferred by the
DTC. For word-size transfer, specify an even destination address.
8.2.5
CRA is a 16-bit register that designates the number of times data is to be transferred by the DTC.
In normal mode, the entire CRA functions as a 16-bit transfer counter (1 to 65,536). It is
decremented by 1 every time data is transferred, and transfer ends when the count reaches H'0000.
In repeat mode or block transfer mode, the CRA is divided into two parts; the upper 8 bits
(CRAH) and the lower 8 bits (CRAL). CRAH holds the number of transfers while CRAL
Bit Name
CHNE
DISEL
—
DTC Mode Register B (MRB)
DTC Source Address Register (SAR)
DTC Destination Address Register (DAR)
DTC Transfer Count Register A (CRA)
Initial Value
Undefined
Undefined
Undefined
R/W
—
—
—
Description
DTC Chain Transfer Enable
When this bit is set to 1, a chain transfer will be
performed. For details, refer to section 8.5.4, Chain
Transfer.
In data transfer with CHNE set to 1, determination of
the end of the specified number of transfers, clearing
of the interrupt source flag, and clearing of DTCER,
are not performed.
DTC Interrupt Select
When this bit is set to 1, a CPU interrupt request is
generated every time after the end of a data transfer.
When this bit is set to 0, a CPU interrupt request is
generated at the time when the specified number of
data transfer ends.
Reserved
These bits have no effect on DTC operation. Only 0
should be written to these bits.
Rev. 7.00 Sep. 11, 2009 Page 107 of 566
Section 8 Data Transfer Controller (DTC)
REJ09B0211-0700