HD64F2612FA20 Renesas Electronics America, HD64F2612FA20 Datasheet - Page 379

• Manufacturer Part Number: HD64F2612FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2612FA20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 43
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

14.4.5
Figure 14.6 shows an example of operation for transmission in asynchronous mode. In
transmission, the SCI operates as described below.
1. The SCI monitors the TDRE flag in SSR. If the flag is cleared to 0, the SCI recognizes that
2. After transferring data from TDR to TSR, the SCI sets the TDRE flag to 1 and starts
3. Data is sent from the TxD pin in the following order: start bit, transmit data, parity bit or
4. The SCI checks the TDRE flag at the timing for sending the stop bit.
5. If the TDRE flag is 0, the data is transferred from TDR to TSR, the stop bit is sent, and then
6. If the TDRE flag is 1, the TEND flag in SSR is set to 1, the stop bit is sent, and then the “mark
Figure 14.7 shows a sample flowchart for transmission in asynchronous mode.
data has been written to TDR, and transfers the data from TDR to TSR.
transmission. If the TIE bit is set to 1 at this time, a transmit data empty interrupt request (TXI)
is generated. Continuous transmission is possible because the TXI interrupt routine writes next
transmit data to TDR before transmission of the current transmit data has been completed.
multiprocessor bit (may be omitted depending on the format), and stop bit.
serial transmission of the next frame is started.
state” is entered, in which 1 is output. If the TEIE bit in SCR is set to 1 at this time, a TEI
interrupt request is generated.
TXI interrupt
request generated
TDRE
TEND
Figure 14.6 Example of Operation in Transmission in Asynchronous Mode
Data Transmission (Asynchronous Mode)
1
Start
bit
0
Data written to TDR and
TDRE flag cleared to 0 in
TXI interrupt service routine
D0
(Example with 8-Bit Data, Parity, One Stop Bit)
D1
1 frame
Data
D7
Parity
bit
0/1
TXI interrupt
request generated
Stop
bit
1
Section 14 Serial Communication Interface (SCI)
Start
bit
0
D0
Rev. 7.00 Sep. 11, 2009 Page 343 of 566
D1
Data
D7
Parity
bit
TEI interrupt
request generated
0/1
Stop
bit
REJ09B0211-0700
1
Idle state
(mark state)
1