HD64F2319VTE25 Renesas Electronics America, HD64F2319VTE25 Datasheet - Page 207

• Manufacturer Part Number: HD64F2319VTE25
• Description: IC H8S MCU FLASH 512K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2319VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

6.6
6.6.1
When the chip accesses external space, it can insert a 1-state idle cycle (T
the following two cases: (1) when read accesses in different areas occur consecutively, and (2)
when a write cycle occurs immediately after a read cycle. By inserting an idle cycle it is possible,
for example, to avoid data collisions between ROM, with a long output floating time, and high-
speed memory, I/O interfaces, and so on.
Consecutive Reads in Different Areas: If consecutive reads in different areas occur while the
ICIS1 bit in BCRH is set to 1, an idle cycle is inserted at the start of the second read cycle. This is
enabled in advanced mode.
Figure 6.16 shows an example of the operation in this case. In this example, bus cycle A is a read
cycle from ROM with a long output floating time, and bus cycle B is a read cycle from SRAM,
each being located in a different area. In (a), an idle cycle is not inserted, and a collision occurs in
cycle B between the read data from ROM and that from SRAM. In (b), an idle cycle is inserted,
and a data collision is prevented.
Address bus
CS (area A)
CS (area B)
Data bus
RD
Idle Cycle
Operation
φ
(a) Idle cycle not inserted
T
1
Bus cycle A
(ICIS1 = 0)
T
Figure 6.16 Example of Idle Cycle Operation (1)
2
T
Long output
floating time
3
Bus cycle B
T
1
T
2
Data
collision
Address bus
CS (area A)
CS (area B)
Data bus
Rev.7.00 Feb. 14, 2007 page 173 of 1108
RD
φ
T
1
(b) Idle cycle inserted
Bus cycle A
(ICIS1 = 1 (initial value))
T
2
Section 6 Bus Controller
I
) between bus cycles in
T
3
REJ09B0089-0700
T
Bus cycle B
I
T
1
T
2