WG82574IT S LBAC Intel, WG82574IT S LBAC Datasheet - Page 467

• Manufacturer Part Number: WG82574IT S LBAC
• Description: CONTROLLER, ENET, INTEL 82574IT, 64PQFN
• Manufacturer: Intel

Specifications of WG82574IT S LBAC

• Ethernet Type: IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
• Supply Voltage Range: 3V To 3.6V
• Operating Temperature Range: -40°C To +85°C
• Digital Ic Case Style: QFN
• No. Of Pins: 64
• Package / Case: QFN
• Interface Type: I2C, JTAG, PCI, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Design Considerations—82574 GbE Controller
13.12
Note:
Figure 91.
Note:
XOR Testing
BSDL files are not available for the 82574 Family.
A common board or system-level manufacturing test for proper electrical continuity
between the 82574 and the board is some type of cascaded-XOR or NAND tree test.
The 82574L implements an XOR tree spanning most I/O signals. The component XOR
tree consists of a series of cascaded XOR logic gates, each stage feeding in the
electrical value from a unique pin. The output of the final stage of the tree is visible on
an output pin from the component.
XOR Tree Concept
By connecting to a set of test-points or bed-of-nails fixture, a manufacturing test
fixture can test connectivity to each of the component pins included in the tree by
sequentially testing each pin, testing each pin when driven both high and low, and
observing the output of the tree for the expected signal value and/or change.
Some of the pins that are inputs for the XOR test are listed as “may be left
disconnected” in the pin descriptions. If XOR test is used, all inputs to the XOR tree
must be connected.
When the XOR tree test is selected, the following behaviors occur:
To enter the XOR tree mode, a specific JTAG pattern must be sent to the test interface.
This pattern is described by the following TDF pattern: (dh = Drive High, dl = Drive
Low)
dh (TEST_EN, JTAG_TDI) dl(JTAG_TCK,JTAG_TMS);
dh(JTAG_TCK);
dl(JTAG_TCK);
dh(JTAG_TMS);
loop 2
dh(JTAG_TCK);
dl(JTAG_TCK);
end loop
dl(JTAG_TMS);
loop 2
dh(JTAG_TCK);
dl(JTAG_TCK);
end loop
• Output drivers for the pins listed as “tested” are all placed in high-impedance (tri-
• Internal pull-up and pull-down devices for pins listed as “tested” are also disabled
• The XOR tree is output on the LED1 pin.
state) state to ensure that board/system test fixture can drive the tested inputs
without contention.
to further ensure no contention with the board/system test fixture.
467