DSP56309EVM Freescale Semiconductor, DSP56309EVM Datasheet - Page 163

• Manufacturer Part Number: DSP56309EVM
• Description: KIT EVALUATION FOR XC56309
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of DSP56309EVM

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Description/function: Audio DSPs
• Product: Audio Modules
• For Use With/related Products: DSP56309
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7.5.7 ESSI Transmit Data Registers (TX[2–0])
ESSI0:TX20, TX10, TX00; ESSI1:TX21, TX11, TX01
TX2, TX1, and TX0 are 24-bit write-only registers. Data written into these registers
automatically transfers to the transmit shift registers. (See Figure 7-12 and Figure 7-13.) The
data transmitted (8, 12, 16, or 24 bits) is aligned according to the value of the ALC bit. When the
ALC bit is cleared, the MSB is Bit 23. When ALC is set, the MSB is Bit 15. If the transmit data
register empty interrupt has been enabled, the DSP is interrupted whenever a transmit data
register becomes empty.
Note:
7.5.8 ESSI Time Slot Register (TSR)
TSR is effectively a write-only null data register that prevents data transmission in the current
transmit time slot. For timing purposes, TSR is a write-only register that behaves as an alternative
transmit data register, except that, rather than transmitting data, the transmit data signals of all the
enabled transmitters are in the high-impedance state for the current time slot.
7.5.9 Transmit Slot Mask Registers (TSMA, TSMB)
Both transmit slot mask registers are read/write registers. When the TSMA or TSMB is read to
the internal data bus, the register contents occupy the two low-order bytes of the data bus, and the
high-order byte is filled by 0. In Network mode the transmitter(s) use these registers to determine
which action to take in the current transmission slot. Depending on the bit settings, the
transmitter(s) either tri-state the transmitter(s) data signal(s) or transmit a data word and generate
a transmitter empty condition.
Freescale Semiconductor
TS11
23
11
—Reserved bit; read as 0; write to 0 0 for future compatibility.
TS10
When data is written to a peripheral device, there is a two-cycle pipeline delay while
any status bits affected by this operation are updated. If any of those status bits are read
during the two-cycle delay, the status bit may not reflect the current status.
22
10
Figure 7-14. ESSI Transmit Slot Mask Register A (TSMA)
TS9
21
9
TS8
20
8
(ESSI0 X:$FFFFB4, ESSI1 X:$FFFFA4)
TS7
DSP56309 User’s Manual, Rev. 1
19
7
TS6
18
6
TS5
17
5
TS4
16
4
TS15
TS3
15
3
TS14
TS2
14
ESSI Programming Model
2
TS13
TS1
13
1
TS12
TS0
12
0
7-31