M30626FJPFP#D5C Renesas Electronics America, M30626FJPFP#D5C Datasheet - Page 391

• Manufacturer Part Number: M30626FJPFP#D5C
• Description: MCU 3/5V 512K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30626FJPFP#D5C

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: I²C, IEBus, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 31K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

M16C/62P Group (M16C/62P, M16C/62PT)
Rev.2.41
REJ09B0185-0241
24.10.2 UART
24.10.3 SI/O3, SI/O4
24.10.2.1 Special Mode 1(I
24.10.2.2 Special Mode 2
24.10.2.3 Special Mode 4 (SIM Mode)
When generating start, stop and restart conditions, set the STSPSEL bit in the UiSMR4 register to “0” and wait
for more than half cycle of the transfer clock before setting each condition generate bit (STAREQ, RSTAREQ
and STPREQ) from “0” to “1”.
If a low-level signal is applied to the NMI pin when the IVPCR1 bit in the TB2SC register = 1 (three-phase
output forcible cutoff by input on NMI pin enabled), the RTS2 and CLK2 pins go to a high-impedance state.
A transmit interrupt request is generated by setting the U2C1 register U2IRS bit to “1” (transmission complete)
and U2ERE bit to “1” (error signal output) after reset is deasserted. Therefore, when using SIM mode, be sure
to clear the IR bit to “0” (no interrupt request) after setting these bits.
The SOUTi default value which is set to the SOUTi pin by the SMi7 bit approximately 10ns may be output
when changing the SMi3 bit from “0” (I/O port) to “1” (SOUTi output and CLK function) while the SMi2 bit in
the SiC (i=3 and 4) to “0” (SOUTi output) and the SMi6 bit is set to “1” (internal clock). And then the SOUTi
pin is held high-impedance.
If the level which is output from the SOUTi pin is a problem when changing the SMi3 bit from “0” to “1”, set
the default value of the SOUTi pin by the SMi7 bit.
Jan 10, 2006
Page 374 of 390
2
C Mode)
24. Precautions