MPC8533EVTARJ Freescale Semiconductor, MPC8533EVTARJ Datasheet - Page 103

• Manufacturer Part Number: MPC8533EVTARJ
• Description: MPU POWERQUICC 783-PBGA
• Manufacturer: Freescale Semiconductor

Specifications of MPC8533EVTARJ

• Processor Type: MPC85xx PowerQUICC III 32-Bit
• Speed: 1.067GHz
• Voltage: 1V
• Mounting Type: Surface Mount
• Package / Case: 783-FCPBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -

21.5
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level. All unused active low inputs should be tied to V
required. All unused active high inputs should be connected to GND. All NC (no connect) signals must
remain unconnected. Power and ground connections must be made to all external V
OV
21.6
The MPC8533E requires weak pull-up resistors (2–10 kΩ is recommended) on open drain type pins
including I
Correct operation of the JTAG interface requires configuration of a group of system control pins as
demonstrated in
state under normal operating conditions as most have asynchronous behavior and spurious assertion will
give unpredictable results.
The following pins must NOT be pulled down during power-on reset: TSEC3_TXD[3], HRESET_REQ,
TRIG_OUT/READY/QUIESCE, MSRCID[2:4], ASLEEP. The DMA_DACK[0:1] and TEST_SEL pins
must be set to a proper state during POR configuration. Refer to the pinout listing table
details. Refer to the PCI 2.2 Local Bus Specifications, for all pullups required for PCI.
21.7
The MPC8533E drivers are characterized over process, voltage, and temperature. For all buses, the driver
is a push-pull single-ended driver type (open drain for I
an external resistor is connected from the chip pad to OV
varied until the pad voltage is OV
components, the resistances of the pull-up and pull-down devices. When data is held high, SW1 is closed
(SW2 is open) and R
Freescale Semiconductor
DD
, GV
Connection Recommendations
Pull-Up and Pull-Down Resistor Requirements
Output Buffer DC Impedance
2
DD
C pins and MPIC interrupt pins.
, and LV
Figure
MPC8533E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 5
P
is trimmed until the voltage at the pad equals OV
DD
65. Care must be taken to ensure that these pins are maintained at a valid deasserted
, and GND pins of the device.
DD
/2 (see
Figure
63). The output impedance is the average of two
DD
2
C). To measure Z
, TV
DD
or GND. Then, the value of each resistor is
DD
, BV
DD
DD
, OV
0
/2. R
for the single-ended drivers,
DD
P
, GV
then becomes the
System Design Information
DD
DD
(Table
, TV
, and LV
DD
57) for more
, BV
DD
DD
as
,
103