EP2S130F1020I5N Altera, EP2S130F1020I5N Datasheet - Page 131

• Manufacturer Part Number: EP2S130F1020I5N
• Manufacturer: Altera

Specifications of EP2S130F1020I5N

• Family Name: Stratix II
• Number Of Logic Blocks/elements: 132540
• # I/os (max): 742
• Frequency (max): 609.76MHz
• Process Technology: 90nm (CMOS)
• Operating Supply Voltage (typ): 1.2V
• Logic Cells: 132540
• Ram Bits: 6747840
• Operating Supply Voltage (min): 1.15V
• Operating Supply Voltage (max): 1.25V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 1020
• Package Type: FC-FBGA
• Lead Free Status / Rohs Status: Compliant

Stratix II
Hot-Socketing
Specifications
Altera Corporation
May 2007
SII51004-3.2
Stratix
or hot swap, and power sequencing support without the use of any
external devices. You can insert or remove a Stratix II board in a system
during system operation without causing undesirable effects to the
running system bus or the board that was inserted into the system.
The hot socketing feature also removes some of the difficulty when you
use Stratix II devices on printed circuit boards (PCBs) that also contain a
mixture of 5.0-, 3.3-, 2.5-, 1.8-, 1.5- and 1.2-V devices. With the Stratix II hot
socketing feature, you no longer need to ensure a proper power-up
sequence for each device on the board.
The Stratix II hot socketing feature provides:
■
■
■
This chapter also discusses the power-on reset (POR) circuitry in Stratix II
devices. The POR circuitry keeps the devices in the reset state until the
V
Stratix II devices offer hot socketing capability with all three features
listed above without any external components or special design
requirements. The hot socketing feature in Stratix II devices allows:
■
■
■
CC
Board or device insertion and removal without external components
or board manipulation
Support for any power-up sequence
Non-intrusive I/O buffers to system buses during hot insertion
is within operating range.
The device can be driven before power-up without any damage to
the device itself.
I/O pins remain tri-stated during power-up. The device does not
drive out before or during power-up, thereby affecting other buses in
operation.
Signal pins do not drive the V
External input signals to I/O pins of the device do not internally
power the V
paths within the device.
®
II devices offer hot socketing, which is also known as hot plug-in
CCIO
or V
CCINT
power supplies of the device via internal
CCIO
4. Hot Socketing &
, V
CCPD
Power-On Reset
, or V
CCINT
power supplies.
4–1