h8s-2635 Renesas Electronics Corporation., h8s-2635 Datasheet - Page 684

no-image

h8s-2635

Manufacturer Part Number
h8s-2635
Description
Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
Manufacturer
Renesas Electronics Corporation.
Datasheet
Section 16 Controller Area Network (HCAN)
Bit 8—Reset Interrupt Flag (IRR0): Status flag indicating that the HCAN module has been
reset. This bit cannot be masked in the interrupt mask register (IMR). If this bit is not cleared after
reset input or recovery from software standby mode, interrupt handling will be performed as soon
as interrupts are enabled by the interrupt controller.
Note: * After reset or hardware standby release, the module stop bit is initialized to 1, and so the
Bits 7 to 5, 3, and 2—Reserved: These bits always read 0. The write value should always be 0.
Bit 4—Bus Operation Interrupt Flag (IRR12): Status flag indicating detection of a dominant bit
due to bus operation when the HCAN module is in HCAN sleep mode.
Rev. 6.00 Feb 22, 2005 page 624 of 1484
REJ09B0103-0600
Bit 8: IRR0
0
1
Bit 4: IRR12
0
1
HCAN enters the module stop state.
Description
[Clearing condition]
Hardware reset (HCAN module stop * , software standby)
[Setting condition]
Description
CAN bus idle state
[Clearing condition]
CAN bus operation in HCAN sleep mode
[Setting condition]
Writing 1
When reset processing is completed after a hardware reset (HCAN
module stop * , software standby)
Writing 1
Bus operation (dominant bit detection) in HCAN sleep mode
(Initial value)
(Initial value)

Related parts for h8s-2635