1893AFLF IDT, 1893AFLF Datasheet - Page 26

• Manufacturer Part Number: 1893AFLF
• Description: Ethernet ICs 3.3V 10/100 BASE TX INTEGRATED PHYCEIVER
• Manufacturer: IDT
• Type: Integrated PHY Transceiverr

Specifications of 1893AFLF

• Rohs: yes
• Product: Ethernet Transceivers
• Data Rate: 10 Mb/s, 100 Mb/s
• Supply Voltage - Max: 3.47 V
• Supply Voltage - Min: 3.14 V
• Maximum Operating Temperature: + 70 C
• Package / Case: SSOP-48
• Ethernet Connection Type: 100Base-TX, 10Base-T
• Maximum Supply Current: 160 mA
• Minimum Operating Temperature: 0 C
• Standard Supported: 802.3
• Part # Aliases: ICS1893AFLF

6.2 Serial Management Interface
6.3 Twisted-Pair Interface
ICS1893AF, Rev D 10/26/04
The ICS1893AF provides an ISO/IEC compliant, two-wire Serial Management Interface as part of its
MAC/Repeater Interface. This Serial Management Interface is used to exchange control, status, and
configuration information between a Station Management entity (STA) and the physical layer device (PHY),
that is, the ICS1893AF.
The ISO/IEC standard also specifies a frame structure and protocol for this interface as well as a set of
Management Registers that provide the STA with access to a PHY such as the ICS1893AF. A Serial
Management Interface is comprised of two signals: a bi-directional data pin (MDIO) along with an
associated input pin for a clock (MDC). The clock is used to synchronize all data transfers between the
ICS1893AF and the STA.
In addition to the ISO/IEC defined registers, the ICS1893AF provides several extended status and control
registers to provide more refined control of the MII and MDI interfaces. For example, the QuickPoll Detailed
Status Register provides the ability to acquire the most-important status functions with a single MDIO read.
Note:
For the twisted-pair interface, the ICS1893AF uses 1:1 ratio transformers for both transmit and receive.
Better operation results from using a split ground plane through the transformer. In this case:
•
•
•
The RJ-45 transformer windings must be on the chassis ground plane along with the Bob Smith
termination.
The ICS1893AF system ground plane must include the ICS1893AF-side transformer windings along with
the 61.9
The transformer provides the isolation with one set of windings on one ground plane and another set of
windings on the second ground plane.
ICS1893AF Data Sheet - Release
In the ICS1893AF, the MDIO and MDC pins remain active for all the MAC/Repeater Interface
modes (that is, 10M MII, 100M MII, 100M Symbol, and 10M Serial).
resistors and the 120-nH inductor.
Copyright © 2004, Integrated Circuit Systems, Inc.
All rights reserved.
26
Chapter 6 Interface Overviews
October, 2004