ATEVK1105 Atmel, ATEVK1105 Datasheet - Page 794

• Manufacturer Part Number: ATEVK1105
• Description: KIT EVAL FOR AT32UC3A0
• Manufacturer: Atmel
• Series: AVR®32r
• Type: MCUr

Specifications of ATEVK1105

• Contents: Evaluation Board, Software and Documentation
• Processor To Be Evaluated: AT32UC3A0512
• Processor Series: AVR
• Data Bus Width: 32 bit
• Interface Type: USART, TWI, USB, SPI, Ethernet
• Operating Supply Voltage: 3.3 V
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: AVR UC3
• Silicon Core Number: AT32UC3A0512
• Silicon Family Name: AVR
• Kit Contents: Board CD Docs
• Rohs Compliant: Yes
• For Use With/related Products: AT32UC3A0
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

41.1.4
41.1.5
41.1.6
41.1.7
41.1.8
32058J–AVR32–04/11
Power Manager
PDCA
TWI
USART
Processor and Architecture
3. SPI Bad Serial Clock Generation on 2nd chip_select when SCBR = 1, CPOL=1 and
4. SPI Glitch on RXREADY flag in slave mode when enabling the SPI or during the first
5. SPI Disable does not work in Slave mode
1. If the BOD level is higher than VDDCORE, the part is constantly under reset
1. Wrong PDCA behavior when using two PDCA channels with the same PID.
1. The TWI RXRDY flag in SR register is not reset when a software reset is performed.
1. ISO7816 info register US_NER cannot be read
1. LDM instruction with PC in the register list and without ++ increments Rp
NCPHA=0
When multiple CS are in use, if one of the baudrate equals to 1 and one of the others doesn't
equal to 1, and CPOL=1 and CPHA=0, then an aditional pulse will be generated on SCK.
Fix/workaround
When multiple CS are in use, if one of the baudrate equals 1, the other must also equal 1 if
CPOL=1 and CPHA=0.
transfer
In slave mode, the SPI can generate a false RXREADY signal during enabling of the SPI or
during the first transfer.
Fix/Workaround
1. Set slave mode, set required CPOL/CPHA.
2. Enable SPI.
3. Set the polarity CPOL of the line in the opposite value of the required one.
4. Set the polarity CPOL to the required one.
5. Read the RXHOLDING register.
Transfers can now befin and RXREADY will now behave as expected.
Fix/workaround
Read the last received data then perform a Software reset.
If the BOD level is set to a value higher than VDDCORE and enabled by fuses, the part will
be in constant reset.
Fix/Workaround
Apply an external voltage on VDDCORE that is higher than the BOD level and is lower than
VDDCORE max and disable the BOD.
Fix/Workaround
The same PID should not be assigned to more than one channel.
Fix/Workaround
After a Software Reset, the register TWI RHR must be read.
The NER register always returns zero.
Fix/Workaround
None
794