ISP1761BE STEricsson, ISP1761BE Datasheet - Page 151

• Manufacturer Part Number: ISP1761BE
• Manufacturer: STEricsson

Specifications of ISP1761BE

• Operating Temperature (min): -40C
• Operating Temperature Classification: Industrial
• Operating Temperature (max): 85C
• Package Type: LQFP
• Rad Hardened: No
• Lead Free Status / Rohs Status: Supplier Unconfirmed

NXP Semiconductors
18. Soldering of through-hole mount packages
ISP1761_5
Product data sheet
18.1 Introduction to soldering through-hole mount packages
18.2 Soldering by dipping or by solder wave
18.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 33. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
Rev. 05 — 13 March 2008
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
Hi-Speed USB OTG controller
temperature
peak
stg(max)
© NXP B.V. 2008. All rights reserved.
ISP1761
001aac844
). If the
time
150 of 163