XE8805AMI028LF Semtech, XE8805AMI028LF Datasheet - Page 40

• Manufacturer Part Number: XE8805AMI028LF
• Description: IC DAS 16BIT FLASH 8K MTP 64LQFP
• Manufacturer: Semtech

Specifications of XE8805AMI028LF

• Applications: Sensing Machine
• Core Processor: RISC
• Program Memory Type: FLASH (22 kB)
• Controller Series: XE8000
• Ram Size: 512 x 8
• Interface: UART, USRT
• Number Of I /o: 24
• Voltage - Supply: 2.4 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 64-LQFP
• Supply Voltage Range: 2.4V To 5.5V
• Operating Temperature Range: -40°C To +85°C
• Digital Ic Case Style: LQFP
• No. Of Pins: 64
• For Use With: XE8000MP - PROG BOARD AND PROSTART2 CARD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The RegSysCtrl register enables the different available reset sources and the sleep mode.
6.7 Watchdog
The watchdog is a timer which has to be cleared at least every 2 seconds by the software to prevent a reset being
generated by the timeout condition.
The watchdog can be enabled by software by setting the EnResWD bit in the RegSysCtrl register to 1. It can then
only be disabled by a power on reset.
The watchdog timer can be cleared by writing consecutively the values Hx0A and Hx03 to the RegSysWD register.
The sequence must strictly be respected to clear the watchdog.
In assembler code, the sequence to clear the watchdog is:
Only writing Hx0A followed by Hx03 resets the WD. If some other write instruction is done to the RegSysWD
between the writing of the Hx0A and Hx03 values, the watchdog timer will not be cleared.
It is possible to read the status of the watchdog in the RegSysWD register. The watchdog is a 4 bit counter with a
count range between 0 and 7. The system reset is generated when the counter is reaching the value 8.
6.8 Start-up and watchdog specifications
At start-up of the circuit, the POR (power-on-reset) block generates a reset signal during t
software execution after this period (see system chapter). The POR is intended to force the circuit in a correct state
at start-up. For precise monitoring of the supply voltage, the voltage level detector (VLD) has to be used.
© Semtech 2006
• when Sleep is set to 1, and SleepEn is 1, the sleep mode is entered. The bit always reads back a 0.
• EnResWD enables the reset due to the watchdog (can not be disabled once enabled).
• EnBusError enables the reset due to a bus error condition.
• EnResPConf enables the reset of the port configurations when reset by Port A, a Bus Error or the
• SleepEn unlocks the Sleep bit. As long as SleepEn is 0, the Sleep bit has no effect.
move AddrRegSysWD, #0x0A
move AddrRegSysWD, #0x03
watchdog.
6-5
POR
XE8805/05A
. The circuit starts
www.semtech.com