am79c970 Advanced Micro Devices, am79c970 Datasheet - Page 74

• Manufacturer Part Number: am79c970
• Description: Pcnettm-pci Single-chip Ethernet Controller For Pci Local Bus
• Manufacturer: Advanced Micro Devices

Note that for some network protocols, the value passed
in the Ethernet Type and/or 802.3 Length field is not
compliant with either standard and may cause
problems.
Receive FCS Checking
Reception and checking of the received FCS is per-
formed automatically by the PCnet-PCI controller. Note
that if the Automatic Pad Stripping feature is enabled,
the FCS for padded frames will be verified against the
value computed for the incoming bit stream including
pad characters, but the FCS value for a padded frame
will not be passed to the host. If an FCS error is detected
in any frame, the error will be reported in the CRC bit
in RMD1.
Receive Exception Conditions
Exception conditions for frame reception fall into two
distinct categories; those which are the result of normal
network operation, and those which occur due to abnor-
mal network and/or host related events.
Normal events which may occur and which are handled
autonomously by the PCnet-PCI controller are basically
collisions within the slot time and automatic runt packet
rejection. The PCnet-PCI controller will ensure that colli-
sions which occur within 512 bit times from the start of
reception (excluding preamble) will be automatically de-
leted from the receive FIFO with no host intervention.
The receive FIFO will delete any frame which is com-
posed of fewer than 64 bytes provided that the Runt
Increasing Time
1010....1010
Preamble
Start of Frame
at Time = 0
Bits
56
10101011
Sync
Bits
8
Figure 28. 802.3 Frame and Length Field Transmission Order
Destination
Address
Bytes
6
P R E L I M I N A R Y
Bit
0
Address
Am79C970
Source
Bytes
Significant
6
Most
Byte
Figure 28 shows the byte/bit ordering of the received
length field for an 802.3 compatible frame format.
Packet Accept (RPA bit in CSR124) feature has not
been enabled. This criterion will be met regardless of
whether the receive frame was the first (or only) frame in
the FIFO or if the receive frame was queued behind a
previously received message.
Abnormal network conditions include:
Host related receive exception conditions include MISS,
BUFF, and OFLO. These are described in the BMU
section.
Loopback Operation
Loopback is a mode of operation intended for system di-
agnostics. In this mode, the transmitter and receiver are
both operating at the same time so that the controller re-
ceives its own transmissions. The controller provides
two types of internal loopback and one type of external
loopback. In internal loopback mode, the transmitted
data can be looped back to the receiver at one of two
places inside the controller without actually transmitting
any data to the external network. The receiver will move
the received data to the next receive buffer, where it can
be examined by software. Alternatively, in external loop-
FCS errors
Late Collision
Bit
7
Length
Bytes
2
Bit
0
Significant
1 — 1500
Bytes
Least
Data
Byte
LLC
46 — 1500
Bytes
Bit
7
45 — 0
Bytes
Pad
Bytes
FCS
AMD
4
18220C-30
1-941