MT48H32M32LFB5-6 IT:B Micron, MT48H32M32LFB5-6 IT:B Datasheet - Page 30

• Manufacturer Part Number: MT48H32M32LFB5-6 IT:B
• Manufacturer: Micron

PDF: 09005aef8404b23d
y68m_mobile_lpsdr.pdf – Rev. D 1/11 EN
10. May or may not be bank specific; if all banks need to be precharged, each must be in a
11. This command is BURST TERMINATE when CKE is HIGH and DEEP POWER-DOWN when
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank specific; requires that all banks are idle.
8. Does not affect the state of the bank and acts as a NOP to that bank.
9. READs or WRITEs listed in the Command/Action column include READs or WRITEs with
Read with auto precharge enabled: Starts with registration of a READ command
with auto precharge enabled and ends when
bank will be in the idle state.
Write with auto precharge enabled: Starts with registration of a WRITE command
with auto precharge enabled and ends when
bank will be in the idle state.
INHIBIT or NOP commands must be applied on each positive clock edge during these
states.
Refreshing: Starts with registration of an AUTO REFRESH command and ends when
t
Accessing mode register: Starts with registration of a LOAD MODE REGISTER com-
mand and ends when
all banks idle state.
Precharging all: Starts with registration of a PRECHARGE ALL command and ends
when
auto precharge enabled and READs or WRITEs with auto precharge disabled.
valid state for precharging.
CKE is LOW.
RFC is met. After
t
RP is met. After
t
RFC is met, the device will be in the all banks idle state.
t
MRD has been met. After
t
RP is met, all banks will be in the idle state.
30
Micron Technology, Inc. reserves the right to change products or specifications without notice.
1Gb: x32 Mobile LPSDR SDRAM
t
t
RP has been met. After
RP has been met. After
t
MRD is met, the device will be in the
© 2010 Micron Technology, Inc. All rights reserved.
t
t
RP is met, the
RP is met, the
Truth Tables