C8051T322-GQR Silicon Labs, C8051T322-GQR Datasheet - Page 162

• Manufacturer Part Number: C8051T322-GQR
• Description: 8-bit Microcontrollers - MCU USB-OTP-16K-LQFP32
• Manufacturer: Silicon Labs

Specifications of C8051T322-GQR

• Rohs: yes
• Core: 8051
• Processor Series: C8051
• Data Bus Width: 8 bit

C8051T620/621/320/321/322/323
USB Register Definition 23.4. INDEX: USB0 Endpoint Index
USB Register Address = 0x0E
23.4. USB Clock Configuration
USB0 is capable of communication as a Full or Low Speed USB function. Communication speed is
selected via the SPEED bit in SFR USB0XCN. When operating as a Low Speed function, the USB0 clock
must be 6 MHz. When operating as a Full Speed function, the USB0 clock must be 48 MHz. Clock options
are described in Section “21. Oscillators and Clock Selection” on page 122. The USB0 clock is selected via
SFR CLKSEL (see SFR Definition 21.1).
Clock Recovery circuitry uses the incoming USB data stream to adjust the internal oscillator; this allows
the internal oscillator to meet the requirements for USB clock tolerance. Clock Recovery should be used in
the following configurations:
When operating USB0 as a Low Speed function with Clock Recovery, software must write 1 to the CRLOW
bit to enable Low Speed Clock Recovery. Clock Recovery is typically not necessary in Low Speed mode.
Single Step Mode can be used to help the Clock Recovery circuitry to lock when high noise levels are pres-
ent on the USB network. This mode is not required (or recommended) in typical USB environments.
162
Name
Reset
7:4
3:0
Bit
Type
Bit
EPSEL[3:0]
Unused
Name
R
7
0
Communication Speed
Unused. Read = 0000b. Write = don’t care.
Endpoint Select Bits.
These bits select which endpoint is targeted when indexed USB0 registers are
accessed.
0000: Endpoint 0
0001: Endpoint 1
0010: Endpoint 2
0011: Endpoint 3
0100-1111: Reserved.
R
6
0
Low Speed
Full Speed
R
5
0
Rev. 1.1
R
4
0
Function
Internal Oscillator / 8
Internal Oscillator
3
0
USB Clock
2
0
EPSEL[3:0]
R/W
1
0
0
0