UPD70F3786GJ-GAE-AX Renesas Electronics America, UPD70F3786GJ-GAE-AX Datasheet - Page 1678

• Manufacturer Part Number: UPD70F3786GJ-GAE-AX
• Description: MCU 32BIT V850ES/JX3-E 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Er

Specifications of UPD70F3786GJ-GAE-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, CSI, EBI/EMI, Ethernet, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 124K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

33.4.6 Pin connection
programmer. Also, incorporate a function on-board to switch from the normal operation mode to the flash memory
programming mode.
status as that immediately after reset.
acknowledge the status immediately after a reset.
1676
When performing on-board writing, mount a connector on the target system to connect to the dedicated flash
In the flash memory programming mode, all the pins not used for flash memory programming become the same
(1) FLMD0 pin
(2) FLMD1 pin
Caution If the V
In the normal operation mode, input a voltage of V
programming mode, supply a write voltage of V
Because the FLMD0 pin serves as a write protection pin in the self programming mode, a voltage of V
must be supplied to the FLMD0 pin via port control, etc., before writing to the flash memory. For details, see
33.5.5 (1) FLMD0 pin.
When 0 V is input to the FLMD0 pin, the FLMD1 pin does not function. When V
pin, the flash memory programming mode is entered, so 0 V must be input to the FLMD1 pin. The following
shows an example of the connection of the FLMD1 pin.
immediately after reset, isolate this signal.
DD
signal is input to the FLMD1 pin from another device during on-board writing and
V850ES/JH3-E,
V850ES/JJ3-E
V850ES/JH3-E,
V850ES/JJ3-E
FLMD0
Figure 33-11. FLMD0 Pin Connection Example
Figure 33-12. FLMD1 Pin Connection Example
FLMD1
Therefore, pin handling is required when the external device does not
CHAPTER 33 FLASH MEMORY
User’s Manual U19601EJ2V0UD
Dedicated flash programmer connection pin
DD
Pull-down resistor (R
Pull-down resistor (R
level to the FLMD0 pin.
SS
level to the FLMD0 pin.
Other device
FLMD0
FLMD1
)
)
DD
is supplied to the FLMD0
In the flash memory
DD
level