MC908LD64IFUE Freescale Semiconductor, MC908LD64IFUE Datasheet - Page 162

• Manufacturer Part Number: MC908LD64IFUE
• Description: IC MCU 8BIT FOR LCD 64-QFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908LD64IFUE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 6MHz
• Connectivity: I²C, USB
• Peripherals: OSD, POR, PWM
• Number Of I /o: 39
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 6x8b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 64-QFP
• Processor Series: HC08LD
• Core: HC08
• Data Bus Width: 8 bit
• Data Ram Size: 2 KB
• Interface Type: I2C, USB
• Maximum Clock Frequency: 6 MHz
• Number Of Programmable I/os: 39
• Number Of Timers: 2
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: FSICEBASE, M68CBL05CE
• Minimum Operating Temperature: 0 C
• On-chip Adc: 8 bit, 6 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Timer Interface Module (TIM)
Data Sheet
162
NOTE:
NOTE:
TOIE — TIM Overflow Interrupt Enable Bit
TSTOP — TIM Stop Bit
Do not set the TSTOP bit before entering wait mode if the TIM is required
to exit wait mode.
TRST — TIM Reset Bit
Setting the TSTOP and TRST bits simultaneously stops the TIM counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
effect. Therefore, a TOF interrupt request cannot be lost due to
inadvertent clearing of TOF. Reset clears the TOF bit. Writing a logic
one to TOF has no effect.
This read/write bit enables TIM overflow interrupts when the TOF bit
becomes set. Reset clears the TOIE bit.
This read/write bit stops the TIM counter. Counting resumes when
TSTOP is cleared. Reset sets the TSTOP bit, stopping the TIM
counter until software clears the TSTOP bit.
Setting this write-only bit resets the TIM counter and the TIM
prescaler. Setting TRST has no effect on any other registers.
Counting resumes from $0000. TRST is cleared automatically after
the TIM counter is reset and always reads as logic zero. Reset clears
the TRST bit.
These read/write bits select either the TCLK pin or one of the seven
prescaler outputs as the input to the TIM counter as
shows. Reset clears the PS[2:0] bits.
1 = TIM counter has reached modulo value
0 = TIM counter has not reached modulo value
1 = TIM overflow interrupts enabled
0 = TIM overflow interrupts disabled
1 = TIM counter stopped
0 = TIM counter active
1 = Prescaler and TIM counter cleared
0 = No effect
Timer Interface Module (TIM)
MC68HC908LD64
Freescale Semiconductor
Table 11-2
—
Rev. 3.0