UPD78F0386GK-8EU-A Renesas Electronics America, UPD78F0386GK-8EU-A Datasheet - Page 139

• Manufacturer Part Number: UPD78F0386GK-8EU-A
• Description: MCU 96KB FLASH 5KB RAM
• Manufacturer: Renesas Electronics America
• Series: 78K0/Lx2r

Specifications of UPD78F0386GK-8EU-A

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LCD, LVD, POR, PWM, WDT
• Number Of I /o: 26
• Program Memory Size: 96KB (96K x 8)
• Program Memory Type: FLASH
• Ram Size: 5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

5.6.2 Example of controlling internal high-speed oscillation clock
(1) When restarting oscillation of the internal high-speed oscillation clock
(2) When using internal high-speed oscillation clock as CPU clock, and internal high-speed oscillation clock or high-
(3) When stopping the internal high-speed oscillation clock
The following describes examples of clock setting procedures for the following cases.
(1) Example of setting procedure when restarting oscillation of the internal high-speed oscillation clock
speed system clock as peripheral hardware clock
(b) To stop X1 oscillation (disabling external clock input) by setting MSTOP to 1
<1> Setting restart of oscillation of the internal high-speed oscillation clock (RCM register)
<2> Waiting for the oscillation accuracy stabilization time of internal high-speed oscillation clock (RCM
Notes 1. After a reset release, the internal high-speed oscillator automatically starts oscillating and the
<1> Confirming the CPU clock status (PCC and MCM registers)
<2> Stopping the high-speed system clock (MOC register)
Caution Be sure to confirm that MCS = 0 or CLS = 1 when setting MSTOP to 1. In addition, stop
When RSTOP is cleared to 0, the internal high-speed oscillation clock starts operating.
register)
Wait until RSTS is set to 1
Confirm with CLS and MCS that the CPU is operating on a clock other than the high-speed system clock.
2. This wait time is not necessary if high accuracy is not necessary for the CPU clock and peripheral
CLS
0
0
1
When CLS = 0 and MCS = 1, the high-speed system clock is supplied to the CPU, so change the
CPU clock to the subsystem clock or internal high-speed oscillation clock.
When MSTOP is set to 1, X1 oscillation is stopped (the input of the external clock is disabled).
internal high-speed oscillation clock is selected as the CPU clock.
hardware clock.
peripheral hardware that is operating on the high-speed system clock.
MCS
0
1
Internal high-speed oscillation clock
High-speed system clock
Subsystem clock
Note 2
CHAPTER 5 CLOCK GENERATOR
.
User’s Manual U17504EJ2V0UD
CPU Clock Status
Note 1
137