ISP1705AETTM STEricsson, ISP1705AETTM Datasheet - Page 47

• Manufacturer Part Number: ISP1705AETTM
• Manufacturer: STEricsson

Specifications of ISP1705AETTM

• Lead Free Status / RoHS Status: Compliant

ISP1705_2
Product data sheet
10.8.3 Remote wake-up
The ISP1705 supports peripherals that initiate remote wake-up resume. When placed into
USB suspend, the peripheral link remembers at what speed it was originally operating.
Depending on the original speed, the link follows one of the protocols detailed here. In
Figure
The sequence of events related to a host and a peripheral, both with ISP1705, is as
follows:
1. Both the host and the peripheral are assumed to be in low-power mode.
2. The peripheral begins remote wake-up by re-enabling its clock and setting its
3. The peripheral begins driving K on the bus to signal resume. Note that the peripheral
4. The host recognizes the resume, re-enables its clock and sets its SUSPENDM bit.
5. The host takes over resume driving within 1 ms of detecting the remote wake-up.
6. The peripheral stops driving resume.
7. The peripheral sees the host continuing to drive the resume.
8. The host stops driving resume and the ISP1705 automatically adds the EOP to the
9. Both the host and the peripheral revert to normal operation by writing 00b to
SUSPENDM bit to 1b.
link must assume that LINESTATE is K (01b) while transmitting because it will not
receive any RXCMDs.
end of the resume. The peripheral recognizes the EOP as the end of resume.
OPMODE. If the host or the peripheral was previously in high-speed mode, it must
revert to high speed before the SE0 of the EOP is completed. This can be achieved
by writing XCVRSELECT[1:0] = 00b and TERMSELECT = 0b after LINESTATE
indicates SE0.
22, timing is not to scale, and not all RXCMD LINESTATE updates are shown.
Rev. 02 — 21 January 2009
ULPI Hi-Speed USB transceiver
© ST-NXP Wireless 2009. All rights reserved.
ISP1705
46 of 89