LSISASX12 LSI, LSISASX12 Datasheet - Page 196

• Manufacturer Part Number: LSISASX12
• Manufacturer: LSI

Specifications of LSISASX12

• Lead Free Status / Rohs Status: Not Compliant

Table 4.11
Register: 0x0318
Read Only
4-118
31
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0x08–0xFF
Phy Op
0x00
0x01
0x02
0x03
0x04
0x05
0x06
0x07
SmpPhyOp Commands
No Operation.
This command clears the Disable STP bit and resets the LSISASx12 STP target.
This command clears the Affiliation Valid and Disable STP bits, and resets the
LSISASx12 STP target.
This command causes any Inbound Open Address Frames targeting the STP
Target to receive OPEN_REJECT (NO DESTINATION). It also prevents
transmission of any Outbound Open Address Frames.
Reserved.
This command clears all the
registers.
This command clears the Affiliation Valid bit.
Activate Port Selector. No operation is performed.
Reserved.
Register Descriptions
Copyright © 2004, 2005 by LSI Logic Corporation. All rights reserved.
24 23
Disable STP
When set, this read-only bit indicates that a SMP PHY
CONTROL(DISABLE) command has disabled the STP
Target. When cleared, this bit indicates the STP Target is
not disabled.
SmpPhyOp
This bit field initiates the commands in
LSISASx12 clears this field one clock after the associated
control signal asserts.
Error Log Invalid Dword Count
This read-only field indicates the number of invalid
dwords received by the STP Target. The value incre-
ments every time the STP Target receives an invalid
Error Log Invalid DWord
16 15
STP Error Status
Operation
register and all of the error count
8 7
0
Table
0 0 0 0
4.11. The
[31:0]
0
[7:0]
0
0
8