n25q064 Numonyx, n25q064 Datasheet - Page 134

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

XIP Operations
10.4
134/154
reset the memory (for devices with a dedicated part number) only when the device is
deselected. See
XIP Memory reset after a controller reset
If during the application life the system controller is reset during operation, and the device
features the RESET functionality (in devices with a dedicated part number), and the feature
has not been disabled, after the controller resets, the memory returns to POR state and
there is no issue. See
In all the other cases, it is possible to exit the memory from the XIP mode by sending the
following rescue sequence at the first chip selection after a system reset:
DQ0= '1' for:
7 clock cycles within S low (S becomes high before 8th clock cycle)
+ 13 clock cycles within S low (S becomes high before 14th clock cycle)
+ 25 clock cycles within S low (S becomes high before 26th clock cycle)
The global effect is only to exit from XIP without any other reset.
Section 16: Ordering
Section 16: Ordering
information.
Micron Technology, Inc., reserves the right to change products or specifications without notice.
information.
©2010 Micron Technology, Inc. All rights reserved.
N25Q064 - 1.8V