n25q064 Numonyx, n25q064 Datasheet - Page 40

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

Volatile and Non Volatile Registers
6.4.5
6.5
6.5.1
40/154
Output Driver Strength VECR<2:0>
The bits from 2 to 0 of the VECR set the value of the output driver strength, enabling to
optimize the impedance at Vcc/2 output voltage for the specific application as described in
Table 7.: Volatile Enhanced Configuration
The default values of Output Driver Strength is set by the dedicated bits of the Non Volatile
Configuration Register (NVCR), the parts are delivered with the output impedance at Vcc/2
equal to 30 Ohms.
Flag Status Register
The Flag Status Register is a powerful tool to investigate the status of the device, checking
information regarding what is actually doing the memory and detecting possible error
conditions.
The Flag status register is composed by 8 bit.Three bits (Program/Erase Controller bit,
Erase Suspend bit and Program Suspend bit) are a “Status Indicator bit”, they are set and
reset automatically by the memory. Four bits (Erase error bit, Program error bit, VPP 1 to 0
error bit and Protection error bit) are “Error Indicators bits”, they are set by the memory
when some program or erase operation fails or the user tries to perform a forbidden
operation. The user can clear the Error Indicators bits by mean of the Clear Flag Status
Register (CLFSR) instruction.
All the Flag Status Register bits can be read by mean of the Read Status Register (RFSR)
instruction.
Table 8.
P/E Controller Status bit
The bit 7 of the Flag Status register represents the Program/Erase Controller Status bit, It
indicates whether there is a Program/Erase internal cycle active. When P/E Controller
Status bit is Low (FSR<7>=0) the device is busy; when the bit is High (FSR<7>=1) the
device is ready to process a new command.
This bit has the same meaning of Write In Progress (WIP) bit of the standard SPI Status
Register, but with opposite logic: FSR<7> = not WIP
It's possible to make the polling instructions, to check if the internal modify operations are
finished, both on the Flag Status register bit 7 or on WIP bit of the Status Register.
7
6
5
4
3
2
1
0
BIT
P/E Controller (not WIP)
Erase Suspend
Erase
Program
VPP
Program Suspend
Protection
RESERVED
Flag Status Register
Description
Micron Technology, Inc., reserves the right to change products or specifications without notice.
Register.
Status
Status
Error
Error
Error
Status
Error
©2010 Micron Technology, Inc. All rights reserved.
Note
N25Q064 - 1.8V