n25q064 Numonyx, n25q064 Datasheet - Page 79

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

N25Q064 - 1.8V
Figure 32. Write Status Register instruction sequence
The protection features of the device are summarized below.
When the Status Register Write Disable (SRWD) bit of the Status Register is 0 (its initial
delivery state), it is possible to write to the Status Register provided that the Write Enable
Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction, regardless
of the whether Write Protect (W/VPP) is driven High or Low.
When the Status Register Write Disable (SRWD) bit of the Status Register is set to '1', two
cases need to be considered, depending on the state of Write Protect (W/VPP):
Regardless of the order of the two events, the Hardware Protected mode (HPM) can be
entered in either of the following ways:
The only way to exit the Hardware Protected mode (HPM) once entered is to pull Write
Protect (W/VPP) High.
If Write Protect (W/VPP) is permanently tied High, the Hardware Protected mode (HPM) can
never be activated, and only the Software Protected mode (SPM), using the Block Protect
(BP3, BP2, BP1, BP0) bits of the Status Register, can be used.
S
C
DQ0
DQ1
If Write Protect (W/VPP) is driven High, it is possible to write to the Status Register
provided that the Write Enable Latch (WEL) bit has previously been set by a Write
Enable (WREN) instruction.
If Write Protect (W/VPP) is driven Low, it is not possible to write to the Status Register
even if the Write Enable Latch (WEL) bit has previously been set by a Write Enable
(WREN) instruction (attempts to write to the Status Register are rejected, and are not
accepted for execution). As a consequence, all the data bytes in the memory area that
are software protected (SPM) by the Block Protect (BP3, BP2, BP1, BP0) bits of the
Status Register, are also hardware protected against data modification.
setting the Status Register Write Disable (SRWD) bit after driving Write Protect
(W/VPP) Low
driving Write Protect (W/VPP) Low after setting the Status Register Write Disable
(SRWD) bit.
0
1
High Impedance
2
Instruction
3
4
5
6
Micron Technology, Inc., reserves the right to change products or specifications without notice.
7
MSB
7
8
6
9 10 11 12 13 14 15
5
register in
4
Status
3
2
1
©2010 Micron Technology, Inc. All rights reserved.
0
Instructions
79/154