n25q064 Numonyx, n25q064 Datasheet - Page 68

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

Instructions
9.1.13
68/154
Dual Input Fast Program (DIFP)
The Dual Input Fast Program (DIFP) instruction is very similar to the Page Program (PP)
instruction, except that the data are entered on two pins (pin DQ0 and pin DQ1) instead of
only one. Inputting the data on two pins instead of one doubles the data transfer bandwidth
compared to the Page Program (PP) instruction.
The Dual Input Fast Program (DIFP) instruction is entered by driving Chip Select (S) Low,
followed by the instruction code, three address bytes and at least one data byte on Serial
Data input (DQ0).
If the 8 least significant address bits (A7-A0) are not all zero, all transmitted data that goes
beyond the end of the current page are programmed from the start address of the same
page (from the address whose 8 least significant bits (A7-A0) are all zero). Chip Select (S)
must be driven Low for the entire duration of the sequence.
If more than 256 bytes are sent to the device, previously latched data are discarded and the
last 256 data bytes are guaranteed to be programmed correctly within the same page. If less
than 256 data bytes are sent to device, they are correctly programmed at the requested
addresses without having any effects on the other bytes in the same page.
For optimized timings, it is recommended to use the Dual Input Fast Program (DIFP)
instruction to program all consecutive targeted bytes in a single sequence rather to using
several Dual Input Fast Program (DIFP) sequences each containing only a few bytes. See
Table 31.: AC
Chip Select (S) must be driven High after the eighth bit of the last data byte has been
latched in, otherwise the Dual Input Fast Program (DIFP) instruction is not executed.
As soon as Chip Select (S) is driven High, the self-timed Page Program cycle (whose
duration is top) is initiated. While the Dual Input Fast Program (DIFP) cycle is in progress,
the Status Register and the Flag Status Register may be read to check if the internal modify
cycle is finished. At some unspecified time before the cycle is completed, the Write Enable
Latch (WEL) bit is reset.
A Dual Input Fast Program (DIFP) instruction applied to a page that is protected by the
Block Protect (BP3, BP2, BP1, BP0 and TB) bits is not executed.
Dual Input Fast Program cycle can be paused by mean of Program/Erase Suspend (PES)
instruction and resumed by mean of Program/Erase Resume (PER) instruction.
Characteristics.
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2010 Micron Technology, Inc. All rights reserved.
N25Q064 - 1.8V