n25q064 Numonyx, n25q064 Datasheet - Page 82

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

Instructions
9.1.27
9.1.28
82/154
S
C
DQ0
DQ1
Table 20.
1. Values of (b1, b0) after power-up are defined in
Read Flag Status Register
The Read Flag Status Register (RFSR) instruction allows the Flag Status Register to be
read. The Status Register may be read at any time, even while a Program, Erase. When one
of these cycles is in progress, it is recommended to check the P/E Controller bit (Not WIP)
bit before sending a new instruction to the device. It is also possible to read the Flag
Register continuously, as shown here.
Figure 35. Read Flag Status Register instruction sequence
Clear Flag Status Register
The Clear Flag Status Register (CLFSR) instruction reset the error Flag Status Register bits
(Erase Error bit, Program Error bit, VPP Error bit, Protection Error bit). It is not necessary to
set the WEL bit before the Clear Flag Status Register instruction is executed. The WEL bit
will be unchanged after this command is executed.
All sectors
0
High Impedance
Sector
1
2
Lock Register in
Instruction
3
4
5
6
b7-b2
Bit
b1
b0
7
7
(1)
8
Flag Status Register Out
6
Sector Lock Down bit value (refer to
Sector Write Lock bit value (refer to
9 10 11 12 13 14 15
5
MSB
4
Micron Technology, Inc., reserves the right to change products or specifications without notice.
Section 7: Protection
3
2
1
0
7
Flag Status Register Out
6
modes.
Value
‘0’
5
©2010 Micron Technology, Inc. All rights reserved.
MSB
4
Table
Table
3
2
19)
19)
1
N25Q064 - 1.8V
0
7