n25q064 Numonyx, n25q064 Datasheet - Page 96

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

Instructions
9.2.12
9.2.13
96/154
Figure 57. Bulk Erase instruction sequence DIO-SPI
Program/Erase Suspend
The Program/Erase Suspend instruction allows the controller to interrupt a Program or an
Erase instruction, in particular: Sector Erase and Dual Command Page Program can be
suspended and erased while Subsector Erase, Bulk Erase, Write Non Volatile Configuration
register, and Program OTP cannot be suspended.
Apart form the parallelizing of the instruction code on the two pins DQ0 and DQ1, the
instruction functionality is exactly the same as the Program/Erase Suspend (PES)
instruction of the Extended SPI protocol.
Figure 58. Program/Erase Suspend instruction sequence DIO-SPI
Program/Erase Resume
After a Program/Erase suspend instruction, a Program/Erase Resume instruction is
required to continue performing the suspended Program or Erase sequence.
Apart form the parallelizing of the instruction code on the two pins DQ0 and DQ1, the
instruction functionality is exactly the same as the Program/Erase Resume (PER)
instruction of the Extended SPI protocol, please refer to
Resume
for further details.
S
C
DQ0
DQ1
S
C
DQ0
DQ1
0
Instruction
Micron Technology, Inc., reserves the right to change products or specifications without notice.
0
Instruction
1
Dual_Program_Erase_Suspend
1
2
2
3
Dual_Bulk_Erase
3
4
Section 9.1.22: Program/Erase
©2010 Micron Technology, Inc. All rights reserved.
N25Q064 - 1.8V