n25q064 Numonyx, n25q064 Datasheet - Page 76

• Manufacturer Part Number: n25q064
• Description: 64mb 1.8v, Multiple I/o, 4kb Subsector Erase, Xip Enabled, Serial Flash Memory With 108 Mhz Spi Bus Interface
• Manufacturer: Numonyx

Instructions
Note:
76/154
Erase to Suspend
Program to
Suspend
SSErase to
Suspend
Suspend Latency
Parameter
After a Program/Erase Suspend instruction the bit 2 of the Flag Status register is
immediately set to 1 and, after a latency time, both the WIP bit of the Status Register and
the Program/Erase controller bit (Not WIP) of the Flag Status Register are cleared (to 0 and
to 1 respectively).
The Suspended state is reset if a power-off is performed or after resume. After a sector
erase instruction has been suspended, another erase instruction is not allowed; however, it
is possible to perform program and reading instructions on all the sectors except the one
whose erase cycle is suspended. Any read instruction issued on this sector outputs Don't
Care data.
After a subsector erase instruction has been suspended, neither an erase instruction or a
program instruction is allowed; only a read instruction is allowed on all sectors except the
one containing the subsector whose erase cycle is suspended. Any read instruction issued
on this sector outputs Don't Care data.
After a program instruction has been suspended, neither a program instruction or an erase
instructions is allowed; however, it is possible to perform a read instruction on all pages
except the one whose program cycle is suspended. Any read instruction issued on this page
outputs Don't Care data.
It's possible to nest a suspend instruction inside another suspended one just once, meaning
that it's possible for example to send to the device an erase instruction, then suspend it,
then send a program instruction and in the end suspend it as well. In this case the next
Program/Erase Resume Instruction resumes the more recent suspended modify cycles,
another Program/Erase Resume Instruction is need to resume also the former one.
Table 16.
Device states are shown in
States. The device can be in only one state at a time, such as Standby, Program, Erase, and
so on.
Sector Erase or Erase Resume to
Erase Suspend
Program Resume to Program
Suspend
Sub Sector Erase or Sub Sector
Erase Resume to Erase Suspend
Program
Sub Sector Erase
Erase
Suspend Parameters
Condition
Table 17.: Operations Allowed / Disallowed During Device
Micron Technology, Inc., reserves the right to change products or specifications without notice.
7
15
15
700
5
50
Typ
Max
µs
µs
µs
µs
µs
µs
Unit
Timing not internally controlled
Timing not internally controlled
Timing not internally controlled
Any Read instruction accepted
Any Read instruction accepted
Any instruction accepted but
DP, SE, SSE, BE, WRSR,
WRNVCR, POTP
©2010 Micron Technology, Inc. All rights reserved.
Note
N25Q064 - 1.8V