PIC18F-LF1XK50 MICROCHIP [Microchip Technology], PIC18F-LF1XK50 Datasheet - Page 151

• Manufacturer Part Number: PIC18F-LF1XK50
• Description: 20-Pin USB Flash Microcontrollers
• Manufacturer: MICROCHIP [Microchip Technology]

REGISTER 15-5:
 2010 Microchip Technology Inc.
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
Note 1:
R/W-0
GCEN
2:
For bits ACKEN, RCEN, PEN, RSEN, SEN: If the I
be set (no spooling) and the SSPBUF may not be written (or writes to the SSPBUF are disabled).
Value that will be transmitted when the user initiates an Acknowledge sequence at the end of a receive.
GCEN: General Call Enable bit (Slave mode only)
1 = Generate interrupt when a general call address 0x00 or 00h is received in the SSPSR
0 = General call address disabled
ACKSTAT: Acknowledge Status bit (Master Transmit mode only)
1 = Acknowledge was not received from slave
0 = Acknowledge was received from slave
ACKDT: Acknowledge Data bit (Master Receive mode only)
1 = Not Acknowledge
0 = Acknowledge
ACKEN: Acknowledge Sequence Enable bit (Master Receive mode only)
1 = Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit.
0 = Acknowledge sequence Idle
RCEN: Receive Enable bit (Master mode only)
1 = Enables Receive mode for I
0 = Receive Idle
PEN: Stop Condition Enable bit (Master mode only)
1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Stop condition Idle
RSEN: Repeated Start Condition Enable bit (Master mode only)
1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Repeated Start condition Idle
SEN: Start Condition Enable/Stretch Enable bit
In Master mode:
1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Start condition Idle
In Slave mode:
1 = Clock stretching is enabled for both slave transmit and slave receive (stretch enabled)
0 = Clock stretching is disabled
ACKSTAT
R/W-0
Automatically cleared by hardware.
SSPCON2: MSSP CONTROL REGISTER (I
W = Writable bit
‘1’ = Bit is set
ACKDT
R/W-0
(2)
ACKEN
2
R/W-0
C
Preliminary
(1)
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
RCEN
2
(1)
C module is not in the Idle mode, these bits may not
R/W-0
(1)
(1)
(1)
2
C MODE)
PIC18F/LF1XK50
(2)
PEN
R/W-0
(1)
(1)
x = Bit is unknown
(1)
RSEN
R/W-0
(1)
DS41350E-page 151
SEN
R/W-0
(1)
bit 0