PIC18F-LF1XK50 MICROCHIP [Microchip Technology], PIC18F-LF1XK50 Datasheet - Page 261

• Manufacturer Part Number: PIC18F-LF1XK50
• Description: 20-Pin USB Flash Microcontrollers
• Manufacturer: MICROCHIP [Microchip Technology]

REGISTER 22-5:
 2010 Microchip Technology Inc.
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 7
bit 6
bit 5-4
bit 3
bit 2
bit 1-0
Note 1:
UOWN
R/W-x
2:
3:
(1)
This bit must be initialized by the user to the desired value prior to enabling the USB module.
This bit is ignored unless DTSEN = 1.
If these bits are set, USB communication may not work. Hence, these bits should always be maintained as
‘0’.
UOWN: USB Own bit
0 = The microcontroller core owns the BD and its corresponding buffer
DTS: Data Toggle Synchronization bit
1 = Data 1 packet
0 = Data 0 packet
Unimplemented: These bits should always be programmed to ‘0’
DTSEN: Data Toggle Synchronization Enable bit
1 = Data toggle synchronization is enabled; data packets with incorrect Sync value will be ignored
0 = No data toggle synchronization is performed
BSTALL: Buffer Stall Enable bit
1 = Buffer stall enabled; STALL handshake issued if a token is received that would use the BD in the
0 = Buffer stall disabled
BC<9:8>: Byte Count 9 and 8 bits
The byte count bits represent the number of bytes that will be transmitted for an IN token or received
during an OUT token. Together with BC<7:0>, the valid byte counts are 0-1023.
DTS
R/W-x
except for a SETUP transaction, which is accepted even if the data toggle bits do not match
given location (UOWN bit remains set, BD value is unchanged)
BDnSTAT: BUFFER DESCRIPTOR n STATUS REGISTER (BD0STAT THROUGH
BD31STAT), CPU MODE (DATA IS WRITTEN TO THE SIDE)
(2)
W = Writable bit
‘1’ = Bit is set
—
U-0
(3)
(1)
—
U-0
Preliminary
(3)
(2)
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
DTSEN
R/W-x
PIC18F/LF1XK50
BSTALL
R/W-x
(3)
.
x = Bit is unknown
R/W-x
BC9
DS41350E-page 261
R/W-x
BC8
bit 0