AT91SAM9G45-EKES Atmel, AT91SAM9G45-EKES Datasheet - Page 703

• Manufacturer Part Number: AT91SAM9G45-EKES
• Description: KIT EVAL FOR AT91SAM9G45
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: MCUr

Specifications of AT91SAM9G45-EKES

• Contents: Board
• Processor To Be Evaluated: SAM9G45
• Data Bus Width: 32 bit
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: - 10 C
• Operating Supply Voltage: 1.8 V to 3.3 V
• For Use With/related Products: AT91SAM9G45
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4626953

35. Ethernet MAC 10/100 (EMAC)
35.1
35.2
6438F–ATARM–21-Jun-10
Description
Embedded Characteristics
The EMAC module implements a 10/100 Ethernet MAC compatible with the IEEE 802.3 stan-
dard using an address checker, statistics and control registers, receive and transmit blocks, and
a DMA interface.
The address checker recognizes four specific 48-bit addresses and contains a 64-bit hash regis-
ter for matching multicast and unicast addresses. It can recognize the broadcast address of all
ones, copy all frames, and act on an external address match signal.
The statistics register block contains registers for counting various types of event associated
with transmit and receive operations. These registers, along with the status words stored in the
receive buffer list, enable software to generate network management statistics compatible with
IEEE 802.3.
• Compatibility with IEEE Standard 802.3
• 10 and 100 MBits per second data throughput capability
• Full- and half-duplex operations
• MII or RMII interface to the physical layer
• Register Interface to address, data, status and control registers
• DMA Interface, operating as a master on the Memory Controller
• Interrupt generation to signal receive and transmit completion
• 128-byte transmit and 128-byte receive FIFOs
• Automatic pad and CRC generation on transmitted frames
• Address checking logic to recognize four 48-bit addresses
• Supports promiscuous mode where all valid frames are copied to memory
• Supports physical layer management through MDIO interface
• Supports Wake-on-LAN. The receiver supports Wake-on-LAN by detecting the following
events on incoming receive frames:
– Magic packet
– ARP request to the device IP address
– Specific address 1 filter match
– Multicast hash filter match
AT91SAM9G45
703