XPSAF5130P SQUARE D, XPSAF5130P Datasheet - Page 24

• Manufacturer Part Number: XPSAF5130P
• Description: SAFETY RELAY 300V 2.5A PREVENTA
• Manufacturer: SQUARE D

Specifications of XPSAF5130P

• Contact Current Max: 30mA
• Contact Voltage Dc Nom: 24V
• Contact Configuration: 3NO
• Relay Mounting: DIN Rail
• External Height: 66mm
• External Width: 114mm
• External Depth: 22.5mm
• Rohs Compliant: Yes

Description (continued)
Safety automation system solutions
Preventa™ safety PLCs
Compact, XPSMF31/30/35
FB1, FB2
FB3
Inputs 1 to 20 Orange
Outputs
1 to 8
24 VDC
RUN
ERROR
PROG
FORCE
FAULT
OSL
BL
RJ45
(1) Depending on PLC model.
Status LED details
Compact safety PLCs XPSMF31222, XPSMF3022 and XPSMF35pp
LED
Green
Green
Red
Orange
Orange
Orange
Orange
Orange
Green
Yellow
Color
–
Orange
Orange
Status
–
On
On
On
On
Off
On
Flashing
Off
On
Off
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
Flashing
Flashing
On
Flashing
Off
On
Flashing
Meaning
Not used.
Communication on Modbus® serial or PROFIBUS DP
(1) active.
Inputs active.
Outputs active.
c 24 V voltage present.
No voltage.
Normal service mode, loaded program running, the
PLC receives I/O messages, communication and
hardware/software tests carried out.
The CPU is in STOP and is not executing any user
application.
All the outputs are reset to a safe, de-energized state.
The CPU is in “ERROR” state (see ERROR).
Software error or hardware anomaly detected by the
CPU.
The monitoring program (Watchdog) has triggered the
STOP state of the process because the programmed
cycle time has been exceeded.
The CPU has stopped the execution of the user
application, ended all hardware and software tests and
all outputs have been reset.
The process can only be started again from the PC.
No errors detected.
The CPU is being loaded with a new configuration.
The FLASH ROM is being loaded with a new operating
system.
No loading of configuration or operating system.
The CPU is in RUN mode and force is active.
The system is not processing (STOP), but force is
prepared and is activated if the dual processor is
started.
Force mode not activated.
Error display for line control.
The user application has caused an error.
The system configuration is defective.
The loading of a new operating system was defective
and the operating system is corrupt.
An error has occurred while writing to FLASH ROM
memory (during updating of the operating system).
One or more I/O errors have occurred.
None of the above errors have occurred.
Emergency loading of the operating system is active.
COM in INIT_Fail state.
Full duplex mode operation.
Signal collision.
Half duplex mode operation, no collision.
Connection established.
Interface active.
2/23
10
10
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9