UPD78F0138HGK-9ET-A Renesas Electronics America, UPD78F0138HGK-9ET-A Datasheet - Page 153

• Manufacturer Part Number: UPD78F0138HGK-9ET-A
• Description: MCU 8BIT 60K FLASH 64TQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx1+r

Specifications of UPD78F0138HGK-9ET-A

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: 3-Wire SIO, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 42
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Cautions 1. When the internal oscillation clock is selected as the clock to be supplied to the CPU, the
Remarks 1. f
2. Figures in parentheses are for operation with f
2. Always set data to PRM00 after stopping the timer operation.
3. If the valid edge of the TI000 pin is to be set for the count clock, do not set the clear & start
4. If the TI000 or TI010 pin is high level immediately after system reset, the rising edge is
5. When the valid edge of the TI010 pin is used, P01 cannot be used as the timer output pin
X
clock of the internal oscillator is divided and supplied as the count clock. If the count clock
is the internal oscillation clock, the operation of 16-bit timer/event counter 00 is not
guaranteed.
selected and supplied to the CPU, the operation of 16-bit timer/event counter 00 is not
guaranteed, either, because the internal oscillation clock is supplied as the sampling clock to
eliminate noise.
mode using the valid edge of the TI000 pin and the capture trigger.
immediately detected after the rising edge or both the rising and falling edges are set as the
valid edge(s) of the TI000 pin or TI010 pin to enable the operation of 16-bit timer counter 00
(TM00). Care is therefore required when pulling up the TI000 or TI010 pin. However, if the
TI000 or TI010 pin is high level when re-enabling operation after the operation has been
stopped, the rising edge is not detected.
(TO00). When P01 is used as the TO00 pin, the valid edge of the TI010 pin cannot be used.
: High-speed system clock oscillation frequency
CHAPTER 6 16-BIT TIMER/EVENT COUNTERS 00 AND 01
When an external clock is used and when the internal oscillation clock is
User’s Manual U16899EJ3V0UD
X
= 10 MHz.
151