20-668-0003 Rabbit Semiconductor, 20-668-0003 Datasheet - Page 128

• Manufacturer Part Number: 20-668-0003
• Description: IC CPU RABBIT2000 30MHZ 100PQFP
• Manufacturer: Rabbit Semiconductor

Specifications of 20-668-0003

• Processor Type: Rabbit 2000 8-Bit
• Speed: 30MHz
• Voltage: 2.7V, 3V, 3.3V, 5V
• Mounting Type: Surface Mount
• Package / Case: 100-MQFP, 100-PQFP
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 30 MHz
• Operating Supply Voltage: 0 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 40
• Number Of Timers: 8 & 10 bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 20-668-0003; 316-1062

Table 12-3 describes the serial port control registers.
122
00—no op
01—receive 1 byte
clocked mode (A,B)
10—send one byte
clocked mode (A,B)
11—reserved for future
use
Bits 7,6—In asynchronous mode, always store zero in these bits. For Ports A and B, if the
Bits 5,4—This enables the standard or alternate pins for the ports. The parallel port output
Bits 3,2—This sets the mode of operation. Modes 10 and 11 apply only to Ports A and B.
Bits 1,0—These bits enable interrupts and set the interrupt priority.
Table 12-3. Serial Port Control Registers (adr = 11xx0100, xx = A,B,C,D)
clocked serial mode is enabled, store the code here to start an operation, either receive or
send. If the clock is internal, a burst of 8 clocks will drive the clock line. In external mode,
the receiver or transmitter waits for an externally supplied burst of 8 clocks.
function for the specified Tx pin becomes disabled when the port is enabled. The settings
in the parallel port C function register (PCFR) and the parallel port D function register
(PDFR) are used to enable the Port C and Port D serial outputs (see Section 9.3, “Parallel
Port C” and Section 9.4, “Parallel Port D” for more details).
Bit 7,6
00—use port C for serial
input
01—use port D for serial
input
1x—disable receiver
input
Bit 5,4
00—async mode, 8 bits
01—async mode 7 bits
10—clocked mode
external clock (A,B)
11—clocked mode
internal clock (A,B)
Rabbit 2000 Microprocessor User’s Manual
Bit 3,2
00—no interrupt
01— priority 1 interrupt
10—priority 2
11—priority 3
Bit 1,0