PIC16LF723A-I/ML Microchip Technology, PIC16LF723A-I/ML Datasheet - Page 31

• Manufacturer Part Number: PIC16LF723A-I/ML
• Description: MCU PIC 3.5K FLASH XLP 28-QFN
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 16Fr

Specifications of PIC16LF723A-I/ML

• Core Size: 8-Bit
• Program Memory Size: 7KB (4K x 14)
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Core Processor: PIC
• Speed: 20MHz
• Connectivity: I²C, SPI, UART/USART
• Number Of I /o: 25
• Program Memory Type: FLASH
• Ram Size: 192 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Data Converters: A/D 11x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 28-VQFN Exposed Pad, 28-HVQFN, 28-SQFN, 28-DHVQFN
• Controller Family/series: PIC16LF
• No. Of I/o's: 25
• Ram Memory Size: 192Byte
• Cpu Speed: 20MHz
• No. Of Timers: 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

3.5
Brown-out Reset is enabled by programming the
BOREN<1:0> bits in the Configuration register. The
brown-out trip point is selectable from two trip points
via the BORV bit in the Configuration register.
Between the POR and BOR, complete voltage range
coverage for execution protection can be imple-
mented.
Two bits are used to enable the BOR. When
BOREN = 11, the BOR is always enabled. When
BOREN = 10, the BOR is enabled, but disabled during
Sleep. When BOREN = 0X, the BOR is disabled.
FIGURE 3-3:
 2010 Microchip Technology Inc.
Note 1: 64 ms delay only if PWRTE bit is programmed to ‘0’.
Brown-Out Reset (BOR)
Internal
Internal
Internal
Reset
Reset
Reset
V
V
V
DD
DD
DD
BROWN-OUT SITUATIONS
< 64 ms
64 ms
PIC16F/LF722A/723A
If V
(T
tions”), the brown-out situation will reset the device.
This will occur regardless of V
not ensured to occur if V
than parameter (T
If V
running, the chip will go back into a Brown-out Reset
and the Power-up Timer will be re-initialized. Once V
rises above V
64 ms Reset.
(1)
BOR
Note:
64 ms
64 ms
DD
DD
) (see Section 23.0 “Electrical Specifica-
drops below V
falls below V
(1)
(1)
When erasing Flash program memory, the
BOR is forced to enabled at the minimum
BOR setting to ensure that any code
protection circuitry is operating properly.
BOR
, the Power-up Timer will execute a
BOR
BOR
BOR
).
DD
while the Power-up Timer is
for greater than parameter
falls below V
V
V
V
BOR
BOR
BOR
DD
slew rate. A Reset is
DS41417A-page 31
BOR
for more
DD