ST7FLITE35F2M6 STMicroelectronics, ST7FLITE35F2M6 Datasheet - Page 109

• Manufacturer Part Number: ST7FLITE35F2M6
• Description: IC MCU 8BIT 8K FLASH 20SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE35F2M6

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: LINSCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE3x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: LINSCI, SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 4
• Operating Supply Voltage: 2.7 V to 5.5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5085 - EVAL BOARD UNIV MOTOR CONTROL497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Table 65. I2Cs_GetCommMode
Notes:
1. In I2Cs_DEFAULT mode, you should use I2Cs_IsReceptionCompleted to detect the start
2. You can directly call this function to get the mode of communication after getting Address
3. If you are calling this function in a loop for detecting the mode of communication then control
Function Name
Function Prototype
Behaviour Description
Input Parameters
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
condition. As by default the slave is considered as a receiver.
matched condition irrespective of whether it is 7-bit or 10-bit address detection.
will not come out of this loop till the first BTF condition occurs. So if BTF is never set then the
program will lose control in the above loop. In this case you can use note (1) to tackle this
problem to detect the error condition inside the loop.
I2Cs_GetCommMode
I2Cs_Mode I2Cs_GetCommMode(void)
It will return I2Cs_DEFAULT mode before first BTF event
and, will return I2Cs_TX_MODE or I2Cs_RX_MODE
mode after that.
None
I2Cs_TX_MODE
Slave is transmitter
I2Cs_RX_MODE
Slave is receiver
I2Cs_DEFAULT
The default mode
I2Cs_IsReceptionCompleted
None
None
None
Function Descriptions
109/235