ST7FLITE35F2M6 STMicroelectronics, ST7FLITE35F2M6 Datasheet - Page 65

• Manufacturer Part Number: ST7FLITE35F2M6
• Description: IC MCU 8BIT 8K FLASH 20SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE35F2M6

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: LINSCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE3x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: LINSCI, SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 4
• Operating Supply Voltage: 2.7 V to 5.5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5085 - EVAL BOARD UNIV MOTOR CONTROL497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Table 34. SPI_PutBuffer
Notes:
– The above function is only for SPI Interrupt driven mode.
– For transmission in software slave mode, you must define SPI_SLAVE_CONFIG in
Caution:
– Do not access the string until transmission is completed.
– Data transmission will stop if any error occurs during transmission.
Function Name
Function Prototype
Behaviour Description
Input Parameter 1
Input Parameter 2
Output Parameters
Required Preconditions
Postconditions
See also
ST7lib_config.h.
SPI_PutBuffer
Void SPI_PutBuffer (const unsigned char *PtrToBuffer,
unsigned char NbOfBytes)
Starts transmission of data in the interrupt service routine,
from the user defined area for SPI Interrupt driven mode.
*PtrToBuffer
Start address of the user buffer.
NbOfBytes
Number of data bytes to be transmitted.
None
1. The SPI should be configured correctly.
2. You must define the transmission mode as SPI Inter-
rupt driven in ST7lib_config.h.
3. You must enable interrupts for this mode.
4. For SPI Interrupt driven mode, SPI_IT_Function must
have been called in the Interrupt service routine.
You can call ‘SPI_IsTransmitCompleted’ after this function
to get the transmission status.
SPI_IsTransmitCompleted, SPI_PutBuffer (SPI Polling
mode)
Function Descriptions
65/235