DRT2-ID32BV-1 Omron, DRT2-ID32BV-1 Datasheet - Page 197

• Manufacturer Part Number: DRT2-ID32BV-1
• Description: 32 In Vert MIL Connector PNP
• Manufacturer: Omron

Specifications of DRT2-ID32BV-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Connector Terminals with Transistors
Mounting in Control
Panels
Mounting to DIN Track
Connecting End Plates
176
Note
Note Always attach End Plate to both ends of Slaves connected to DIN Track.
Either of the following three methods can be used to mount an Remote I/O
Terminal in a control panel.
1. There are restriction when using the 32-point Transistor Remote I/O Termi-
2. Remote I/O Terminals with Connectors cannot be mounted to a control
Mount the back of the Remote I/O Terminal to a 35-mm DIN Track. To mount
the Terminal, pull down on the mounting hook on the back of the Terminal with
a screwdriver, insert the DIN Track on the back of the Terminal, and then
secure the Terminal to the DIN Track. When finished, secure all Slaves on
both ends of the DIN Track with End Plates.
Hook the bottom of the End Plate onto the DIN Track, as shown at (1) in the
following diagram, then hook the top of the End Plate as shown at (2).
• Mounting to DIN Track
• Mounting perpendicular to a panel using a Mounting Bracket
• Mounting parallel to a panel using a Mounting Bracket
• If the Terminals are not mounted facing up, they can be mounted side-by-
• If the Terminals are mounted facing up, the distances and temperatures in
nals with Connectors or 32-point Transistor Remote Input Terminals with
Connectors depending on the ambient operating temperature.
side and all inputs can be turned ON simultaneously at 55 ° C or less.
the graph given below must be maintained to enable turning ON all inputs
simultaneously. For example, at an ambient temperature of 55 ° C, the Ter-
minals must be separated by at least 10 mm.
panel with just screws; the SRT2-ATT02 Mounting Bracket B (sold sepa-
rately) must be used.
L
L
10
30
20
0
40
Ambient operating temp. (°C)
45
50
2
1
55
Section 5-6