DRT2-ID32BV-1 Omron, DRT2-ID32BV-1 Datasheet - Page 402

• Manufacturer Part Number: DRT2-ID32BV-1
• Description: 32 In Vert MIL Connector PNP
• Manufacturer: Omron

Specifications of DRT2-ID32BV-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Setting Using the
DeviceNet Configurator
Temperature Input Terminals
1,2,3...
Note
If the settings are incorrect, the MS Indicator will flash red and the Unit will not
operate. In this case, make the settings again and reset the power supply.
DRT2-TS04P
If the settings are incorrect, the MS Indicator will flash red and the Unit will not
operate. In this case, make the settings again and reset the power supply.
1. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
2. The DIP switch settings are read when the power is turned ON.
3. The 1/100 display mode and
4. When the display mode is set to 1/100 display mode with the DIP switch
5. When a DRT1-series Temperature Input Terminal (DRT1-TS04T or
Use the following procedure to set the input type for each input using the Con-
figurator.
1. Double-click the icon of the Slave to be set in the Main Window and open
2. Select the Tab Page for the input where the sensor settings will be set.
OFF
ON
OFF
ON
SW1
is OFF, the DIP switch settings will not be enabled.
each input.
(pin 5 ON), the connection path must be set with the configurator. Refer to
7-6-2 Temperature Input Terminal Display Modes for details.
If “1/100 display” is not selected in the I/O data in the connection path set-
tings from the Configurator, the temperature data will be 0.
DRT1-TS04P) is being replaced with one of these DRT2-series Slaves and
the 1/100 display mode is being used, refer to the following table and set
the appropriate display mode.
the Edit Device Parameters Window. (From the Maintenance Mode Win-
dow, click the right mouse button over the Slave icon and select Parame-
ters and Edit.)
OFF
OFF
ON
SW7
OFF
OFF
ON
ON
SW2
OFF
ON
Not used.
Always OFF.
SW5
SW3
°C/°F display settings cannot be set individually for
Normal display
1/100 display
DRT1-compatible 1/100 display
SW4
PT
JPT
PT2
JPT2
Display mode
Input type
Section 7-6
381