DRT2-ID32BV-1 Omron, DRT2-ID32BV-1 Datasheet - Page 338

• Manufacturer Part Number: DRT2-ID32BV-1
• Description: 32 In Vert MIL Connector PNP
• Manufacturer: Omron

Specifications of DRT2-ID32BV-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Input Range Settings
Analog Input Terminals
Note
Note
■ Inputs 0 and 1 (Shared Setting)
■ Inputs 2 and 3 (Shared Setting)
Each pin is set according to the following table.
1. When using the DRT2-AD04H, always set pin 7 to its default setting (OFF).
2. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
3. The DIP switch settings are read when the power is turned ON.
1. When the DIP switch is used to set the input ranges (pin 8 ON), the input
2. When all the four inputs (inputs 0 to 3) are not being used in the
1
2
3
4
5
6
7
8
0 to 5 V
1 to 5 V
0 to 10 V
–10 to 10 V
4 to 20 mA
0 to 20 mA
Cannot set for other ranges.
0 to 5 V
1 to 5 V
0 to 10 V
–10 to 10 V
4 to 20 mA
0 to 20 mA
Cannot set for other ranges.
Pin No.
is OFF, the DIP switch settings will not be enabled.
signal ranges will always be the same for Inputs 0 and 1 and for Inputs 2
and 3. If it is necessary to set separate input signal ranges for Inputs 0 to
3, use the Configurator to make the settings rather than the DIP switch.
When pin 8 is OFF, the other DIP switch settings are disabled.
DRT2-AD04, the number of AD conversion points can be set using the
Configurator to speed up the conversion cycle for each input. Refer to
7-4-3 Functions and Settings and 7-4-4 Calculating the Conversion Cycle
(DRT2-AD04 Only).
Signal range
Signal range
Input Terminal: Input range set-
ting for Inputs 0 and 1.
Input Terminal: Input range set-
ting for Inputs 2 and 3.
AD conversion data format setting ON: Signed binary
Range setting method
Setting
OFF
ON
OFF
ON
OFF
ON
---
OFF
ON
OFF
ON
OFF
ON
---
Pin 4
Pin 1
Default setting: All pins OFF
Default setting: All pins OFF
OFF: Two’s complement
OFF: Use Configurator.
ON: Use DIP switch.
The other DIP switch settings are
disabled when pin 8 is OFF.
Default setting: OFF
OFF
OFF
ON
ON
OFF
OFF
---
OFF
OFF
ON
ON
OFF
OFF
---
Pin 2
Pin 5
Specifications
OFF
OFF
OFF
OFF
ON
ON
---
OFF
OFF
OFF
OFF
ON
ON
---
Section 7-4
Pin 3
Pin 6
317