ATtiny20 Atmel Corporation, ATtiny20 Datasheet - Page 142

• Manufacturer Part Number: ATtiny20
• Manufacturer: Atmel Corporation

Specifications of ATtiny20

• Flash (kbytes): 2 Kbytes
• Pin Count: 14
• Max. Operating Frequency: 12 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 5
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 12
• Ext Interrupts: 12
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 0.12
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 4
• Input Capture Channels: 1
• Pwm Channels: 3
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

Figure 17-6. Master Read Transaction
Given that the slave acknowledges the address, the master can start receiving data from the
slave. There are no limitations to the number of data packets that can be transferred. The slave
transmits the data while the master signals ACK or NACK after each data byte. The master ter-
minates the transfer with a NACK before issuing a STOP condition.
Figure 17-7
illustrates a combined transaction. A combined transaction consists of several read
and write transactions separated by a Repeated START conditions (Sr).
Figure 17-7. Combined Transaction
17.3.7
Clock and Clock Stretching
All devices connected to the bus are allowed to stretch the low period of the clock to slow down
the overall clock frequency or to insert wait states while processing data. A device that needs to
stretch the clock can do this by holding/forcing the SCL line low after it detects a low level on the
line.
Three types of clock stretching can be defined as shown in
Figure
17-8.
Figure 17-8. Clock Stretching
If the device is in a sleep mode and a START condition is detected the clock is stretched during
the wake-up period for the device.
A slave device can slow down the bus frequency by stretching the clock periodically on a bit
level. This allows the slave to run at a lower system clock frequency. However, the overall per-
formance of the bus will be reduced accordingly. Both the master and slave device can
randomly stretch the clock on a byte level basis before and after the ACK/NACK bit. This pro-
vides time to process incoming or prepare outgoing data, or performing other time critical tasks.
ATtiny20
142
8235B–AVR–04/11