M30800SFP-BL#U5 Renesas Electronics America, M30800SFP-BL#U5 Datasheet - Page 358

• Manufacturer Part Number: M30800SFP-BL#U5
• Description: MCU 3/5V 0K,PB-FREE 100-QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/80r

Specifications of M30800SFP-BL#U5

• Core Processor: M16C/80
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 45
• Program Memory Type: ROMless
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

M
1
6
Version
Rev.1.0
C
8 /
0
G
o r
Page 221 Notes on CNVSS pin reset at "H" level --> added
Page 222 Microprocesser mode or Memory expansion mode --> added
Page 222 Microprocessor(Usage Precaution) --> added
Page 227 Table 28.3 , Table 28.4 --> added
Page 249 (Note 4) contained in the title of Table 28.23 --> deleted
Page 274 Read data from an even address in the user ROM area when reading the status
Page 278 main clock frequency --> BCLK
Page 279 Table 30.1 Read status register command's second bus cycle 'X' --> 'X(Note 6)
Page 286 Figure 30.8 (When reading the status register,set an even number address in the
Page 287 Figure 30.9 ROM code protect level 2 set bit --> deleted, Notes 3 to 5 --> added
Page 289 In this mode, the M16C/80 (flash memory version) operates in a manner similar to
Page 7,271,323 Mitsubishi-->Renesas
Page 289 Mitsubishi -->deleted
Page 294 from Mitsubisi --> from the factory
Page 323 Mitsubisi --> the following
All Pages Words standardized: A/D converter, D/A converter and XY converter
All Pages Figure number and Table number change
u
p
register. --> added
Note 6 (that is an even address) --> added
user ROM area). --> added
example:
mov.b #02H,PRCR
bset 3,PM0
nop
nop
nop
nop
the flash memory M5M29FB/T800 from Mitsubishi. Since there are some
differences with regard to the functions not available with the microcomputer and
matters related to memory capacity, the M16C/80 cannot be programed by a
pro gramer for the flash memory. --> deleted
start up in microprocessor mode, write at least three NOP instructions following
If the software reset is executed when the CNVss pin is connected to Vcc to
the writing instruction to the PM0 Register.
; or "mov.b #8BH,PM0" (instruction to execute software reset)
; write at least three NOP instructions
Contents for change
revised
revised
C - 16
revised
Revision History
02/08/'05
Revision
date